Hi, its me again. (See 'cloning - is this correct?'
Following on from finding a problem with my Advanced dock bay not working, just as I was about to clone my T60 drive, our IT service company (in the same building) offered to clone it for me, using their equipment and external enclosure.
I dropped the drives off this afternoon and they were just delivered back to me.
Put the new 250Gb Scorpio Blue in the drive bay and tried to boot up, but just getting a blinking cursor in top left of screen.
Changed drives and booted up from old drive - no problem.
I am sure I have read about this previously, but can't find out where.
What is the problem likely to be?
More importantly, what is the solution?
: Added link to referenced thread on the first line.