Take a look at our
ThinkPads.com HOME PAGE
For those who might want to contribute to the blog, start here: Editors Alley Topic
Then contact Bill with a Private Message

Installing OS/2 on Thinkpad T43

OS/2 on ThinkPads
Post Reply
Message
Author
Qrani
Posts: 20
Joined: Mon Nov 25, 2019 9:44 pm
Location: Ann Arbor, Michigan

Installing OS/2 on Thinkpad T43

#1 Post by Qrani » Mon Mar 02, 2020 10:26 pm

Hello, I've been trying to install OS/2 on my new Thinkpad T43, which I may add, has the original HDD with original OEM install and recovery partition, but I always get an error when trying to install OS/2 on the part where I set video/network adapters, and put in username and password, and it has to restart, and when I restart, I get this:

Code: Select all


Exception in module:
TRAP 000d        ERRCD=0000  ERACC=****  ERLIM=********

...

The system detected an internal processing error at
location ##0168:fff1ev1c - 000e:cb1c.
60000, 9084

078606d8
Internal revision 14.086_W4

The system is stopped.  Record all of the above information and
contact you service representative.

I can't figure out why it always gives me this error, on this one part. I followed this forum post about installing OS/2 Warp 4.52 on a T43 viewtopic.php?t=120744, but even after following the steps exactly, I still always got the error.

Also, before the screen with the previous error, I always get this error:

Code: Select all


SYS1201: The device driver C:\OS2\BOOT\COM.SYS specified in the DEVICE
statement
on line 88 of the CONFIG.SYS file was not installed.  Line 88
is ignored.

  • Thinkpad 770z
  • Thinkpad T43

micrex22
Junior Member
Junior Member
Posts: 402
Joined: Fri Jan 02, 2015 12:22 am
Location: Vancouver, BC, Canada

Re: Installing OS/2 on Thinkpad T43

#2 Post by micrex22 » Fri May 08, 2020 3:45 am

You will need to revisit this step because the trap is generated specifically when the wrong video is selected:
#12 you'll finally get to the setup screen, for video you MUST choose *Super VGA* (it's further DOWN in the list), DO NOT choose the default video selection that the installer thinks it wants. Else you'll get a trap error once the installer restarts.
Don't choose any networking devices, the 4.52 vanilla media does not have the drivers, those have to be installed later which is mentioned in my guide:
#4 OS/2 Broadcom ethernet driver
Follow Broadcom's official instructions to add the driver files in MPTS Network Adapters and Protocol Services. Remove the following from OS/2's startup folder: Network Messaging. You will need to manually configure OS/2 to run TCP/IP on DHCP on eth0: TCP/IP Configuration found under system setup.
Generally you don't want the Windows XP recovery partition, OS/2 prefers having a completely blanked disk to deploy its partitions. This is also mentioned in my guide:
#3 format the drive, I would advise to formatting it completely with MHDD or Nuke 'n Boot

Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “OS/2 Questions”

Who is online

Users browsing this forum: No registered users and 4 guests