FS: FlexView LCD for A31p 15" 1600X1200
Posted: Sat Oct 13, 2007 8:54 pm
I have available a FlexView LCD for any A30 or A31 computer. This is the screen that comes with an A30p or A31p, but I have found that the complete assembly should work on any A3X (at least, I have put an XGA screen onto an A30p and it worked fine).
This is NOT a grade A panel. It has some red tint at startup, then the red goes away and it looks fine (see attached photo). I did try another inverter, and there was still some pink, but not as much. It also has some "yellowish" tint on the left and right ends. No lines, no dead pixels, no dead areas. This is a totally usable LCD, and it will be offered at an appropriate price.
FlexView LCDs are hard to find, and usually sell for $250-300
I would like to get $75 for this panel, or $95 for the complete assembly, which includes the inverter and cable. All are tested working. The left latch is broken, and the bezel should be replaced for best cosmentics.
All prices are plus shipping, I think a flat rate box for around $12.00 will do it.
I meant to also note the FRU, but I forgot before I put it back into the assembly! Be assured, this is a pull from a working A31p (I obtained a top unit with wifi antennas, but my original LCD was better than this one) so this is the entire top unit that came off that machine, with the swapped LCD.
Email scosgt@worldnet.att.net
PayPal is OK
pic here:
ftp://24.184.37.116/LCD.jpg
This is NOT a grade A panel. It has some red tint at startup, then the red goes away and it looks fine (see attached photo). I did try another inverter, and there was still some pink, but not as much. It also has some "yellowish" tint on the left and right ends. No lines, no dead pixels, no dead areas. This is a totally usable LCD, and it will be offered at an appropriate price.
FlexView LCDs are hard to find, and usually sell for $250-300
I would like to get $75 for this panel, or $95 for the complete assembly, which includes the inverter and cable. All are tested working. The left latch is broken, and the bezel should be replaced for best cosmentics.
All prices are plus shipping, I think a flat rate box for around $12.00 will do it.
I meant to also note the FRU, but I forgot before I put it back into the assembly! Be assured, this is a pull from a working A31p (I obtained a top unit with wifi antennas, but my original LCD was better than this one) so this is the entire top unit that came off that machine, with the swapped LCD.
Email scosgt@worldnet.att.net
PayPal is OK
pic here:
ftp://24.184.37.116/LCD.jpg
