WTB/Borrow: Programming cable for QXGA panel
Posted: Wed May 20, 2009 3:40 pm
So, I just got a QXGA panel, and will need to reprogram the EDID flash for a T60/p.
Here's the deal, I can't solder very well, and even if I could, my equipment sucks, so I'm utterly failing at making the part of the QXGA programmer that actually plugs into the LCD. I've got the Easy I2C circuit done on a breadboard, so I just need a cable to go from the LCD to the breadboard.
If anyone's got one that they wouldn't mind either selling me or letting me borrow, or is able to make one without much difficulty (http://users.cybercity.dk/~dsl35822/edidconnection.jpg is the pinout, and it's made from the end of any LCD cable for a R5/T4/R6/T6 series machine,) let me know. I'm in 43055.
Here's the deal, I can't solder very well, and even if I could, my equipment sucks, so I'm utterly failing at making the part of the QXGA programmer that actually plugs into the LCD. I've got the Easy I2C circuit done on a breadboard, so I just need a cable to go from the LCD to the breadboard.
If anyone's got one that they wouldn't mind either selling me or letting me borrow, or is able to make one without much difficulty (http://users.cybercity.dk/~dsl35822/edidconnection.jpg is the pinout, and it's made from the end of any LCD cable for a R5/T4/R6/T6 series machine,) let me know. I'm in 43055.
