Is switching the LCD On/Off bad for it ?

Performance, hardware, software, general buying and gaming discussion..
Post Reply
Message
Author
wearetheborg
Senior Member
Senior Member
Posts: 569
Joined: Sun Oct 22, 2006 1:12 am
Location: San Pablo, California

Is switching the LCD On/Off bad for it ?

#1 Post by wearetheborg » Thu Sep 20, 2007 7:56 am

In my laptop, I've set the lcd to turn off after 15 min of inactivty. If the LCD repeatedly gets turned on/off because of it in a day, is it bad for it ?
HP NC8000 UXGA; Dell Precision M90 WUXGA; R50P UXGA
Please PM me if you've had experience with SquareTrade warranties

carbon_unit
Moderator Emeritus
Moderator Emeritus
Posts: 2988
Joined: Sat Apr 24, 2004 9:10 pm
Location: South Central Iowa, USA

#2 Post by carbon_unit » Thu Sep 20, 2007 8:09 am

No, it won't hurt it.
T60 2623-D7U, 3 GB Ram.
Dual boot XP and Linux Mint.
Registered linux user #160145

rkawakami
Admin
Admin
Posts: 10055
Joined: Sun Jun 04, 2006 1:26 am
Location: San Jose, CA 95120 USA
Contact:

#3 Post by rkawakami » Thu Sep 20, 2007 11:37 am

I'm of a different opinion.... Since the CCFL is a fluorescent lamp I would assume it will be affected like its bigger cousins:

http://members.misty.com/don/f-lamp.html
http://www.eere.energy.gov/consumer/you ... opic=12280
http://www.lightingdesignlab.com/articl ... escent.htm
http://www.consumerenergycenter.org/myt ... ights.html
http://www.newton.dep.anl.gov/askasci/e ... g99369.htm

(Googled "fluorescent lamp frequent on off")

While the general consensus is that it's hard to say whether or not it's more energy efficient to leave a FL on for some indeterminate time vs. turning them off, frequent on-off cycles does appear to lessen the life. Going to the other extreme, I would also not leave the lamp on 24/7. Having the CCFL shut off after 15 minutes and then waking up the system right away may not be good for the lamp. However, you probably don't do that too much. I'd assume that the laptop shuts off the display and maybe you don't get back to it for a few hours, so it's really not being turned off and on every 15 minutes.
Ray Kawakami
X22 X24 X31 X41 X41T X60 X60s X61 X61s X200 X200s X300 X301 Z60m Z61t Z61p 560 560Z 600 600E 600X T21 T22 T23 T41 T60p T410 T420 T520 W500 W520 R50 A21p A22p A31 A31p
NOTE: All links to PC-Doctor software hosted by me are dead. Files removed 8/28/12 by manufacturer's demand.

beeblebrox
**SENIOR** Member
**SENIOR** Member
Posts: 760
Joined: Thu Nov 11, 2004 3:22 pm
Location: No location is OK - BillM

#4 Post by beeblebrox » Tue Sep 25, 2007 11:14 am

rkawakami wrote:I'm of a different opinion.... Since the CCFL is a fluorescent lamp I would assume it will be affected like its bigger cousins:

http://members.misty.com/don/f-lamp.html
http://www.eere.energy.gov/consumer/you ... opic=12280
http://www.lightingdesignlab.com/articl ... escent.htm
http://www.consumerenergycenter.org/myt ... ights.html
http://www.newton.dep.anl.gov/askasci/e ... g99369.htm

(Googled "fluorescent lamp frequent on off")

While the general consensus is that it's hard to say whether or not it's more energy efficient to leave a FL on for some indeterminate time vs. turning them off, frequent on-off cycles does appear to lessen the life. Going to the other extreme, I would also not leave the lamp on 24/7. Having the CCFL shut off after 15 minutes and then waking up the system right away may not be good for the lamp. However, you probably don't do that too much. I'd assume that the laptop shuts off the display and maybe you don't get back to it for a few hours, so it's really not being turned off and on every 15 minutes.
Don't worry about your LCD lamp. Turn it off as much as you need. Modern LCD lamps are controlled by sophisticated electronics (which resides in the inverter board). To start the lamp you need to ionize the inner gas. In old lamps an inductor and bimetall is used to induce a shock ionization. Not good, because of wear and tear of the electrodes. That's why old lamps in supermarkets sometimes flicker (they are dying). LCD lamps use radioactive substances to pre-ionize the gas. Don't worry about on/off cycles. In fact, once the gas is ionized you can use the lamps as stroboskopes (have a look at some discotheques).
Your main worry is the coating of the lamp. The 3 differents coatings decay differently and your lamp will experience different temperature induced color variations, such as reddish and yellowish colors. Your lamp usually will become useless with wrong color temperature, before the electrodes might wear out. Besides, a new lamp costs only $20,-
which is peanuts...

pianowizard
Senior ThinkPadder
Senior ThinkPadder
Posts: 8368
Joined: Tue Jun 28, 2005 5:07 am
Location: Ann Arbor, MI
Contact:

#5 Post by pianowizard » Tue Sep 25, 2007 11:19 am

If you worry about turning it on and off frequently, why not dim it down instead. I do that whenever I am away for longer than a few minutes.
Microsoft Surface 3 (Atom x7-Z8700 / 4GB / 128GB / LTE)
Dell OptiPlex 9010 SFF (Core i3-3220 / 8GB / 8TB); HP 8300 Elite minitower (Core i7-3770 / 16GB / 9.25TB)
Acer T272HUL; Crossover 404K; Dell 3008WFP, U2715H, U2711, P2416D; Monoprice 10734; QNIX QHD2410R; Seiki Pro SM40UNP

Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “Thinkpad - General HARDWARE/SOFTWARE questions”

Who is online

Users browsing this forum: No registered users and 9 guests