New hard drive install have factory restore disks
Posted: Mon Jul 20, 2009 6:11 pm
Hi;
I am a newbee to the forum, and find it very informative, and lots of good info. I
have a R40 2723-LU7, original factory restore disks (p/n 01R8517), and a new
Hitachi 60 gig hard drive (DK23FB-60). I tried to do a restore to this hard drive
which failed. The first disk went fine the second made it about 97%, then said
“unable to read disk”, (unknown hard drive or restore cd), clicked ok then went to
black screen with cursor blinking.
In reading threads I see that my drive might not be set up correctly (beers/parties),
as I saw during the install, something about unable to write or maybe unable to read
BEERS. Anyway is there a program that will make the drive firmware do
BEERS/PARTIES, and where can I get it? Second, if I correct my drive issue, will
the factory restore disks function correctly, or do I need format the drive or do
something else? If so what is the next step? After the botched restore I used PC
DOC on the restore disk to clear the disk. Since it took about 4+ hours to do, I
assume that it wrote “Os” to the drive, but I have not checked yet. I have changed
the modem card to a bluethooth / modem card and changed the original 802.11A
card to a 802.11 A/B/G card. Will this affect my restore? I have 2 R40s, I plan to
put a new drive in the second one and give to a friend. The restore disks will work
on both, but I am not changing the modem or wireless card on the second, so I
would like the restore to work on both. Any and all assistance would be greatly
accepted!!
Thanks
Randy
I am a newbee to the forum, and find it very informative, and lots of good info. I
have a R40 2723-LU7, original factory restore disks (p/n 01R8517), and a new
Hitachi 60 gig hard drive (DK23FB-60). I tried to do a restore to this hard drive
which failed. The first disk went fine the second made it about 97%, then said
“unable to read disk”, (unknown hard drive or restore cd), clicked ok then went to
black screen with cursor blinking.
In reading threads I see that my drive might not be set up correctly (beers/parties),
as I saw during the install, something about unable to write or maybe unable to read
BEERS. Anyway is there a program that will make the drive firmware do
BEERS/PARTIES, and where can I get it? Second, if I correct my drive issue, will
the factory restore disks function correctly, or do I need format the drive or do
something else? If so what is the next step? After the botched restore I used PC
DOC on the restore disk to clear the disk. Since it took about 4+ hours to do, I
assume that it wrote “Os” to the drive, but I have not checked yet. I have changed
the modem card to a bluethooth / modem card and changed the original 802.11A
card to a 802.11 A/B/G card. Will this affect my restore? I have 2 R40s, I plan to
put a new drive in the second one and give to a friend. The restore disks will work
on both, but I am not changing the modem or wireless card on the second, so I
would like the restore to work on both. Any and all assistance would be greatly
accepted!!
Thanks
Randy