Wireless Problem Startup - no connection
Posted: Sun Jul 18, 2010 4:55 am
I have a strange problem with the wireless card in one of my TP's (R31) - an I assume that different programs at boottime do interfer and screw up the system.
When I start (one of my) Thinkpad (no LAN Cable attached), then I have no correct connection to the Network.
Browser fails, ping also.
Going into Thinkvantage Access Connections, press the button "disconnect" (I guess that is the label, I am using a German version labelled "trennen") and "connect" thereafter, everything works just fine.
Here is more info about the machine's symptons / settings:
1.) I use it with a fixed fix IP adress
2.) There is an icon in the tray saying "Data Frame Errors - Check WEP Settings." It seems to be the "AEIWLSTA.EXE" programm that I do not see on other TP's that I am useing and running with Access connections.
3.) When I run ThinkVanmtage Access Connections, it shows "all ok", the Wireless setting to be ok, 93 to 100% signal strength
4.) When i open this other icon, The "PRISM Wirelss properties" Programm opens and basically says very good connection etc.
What do I need to do to cure the problem? I assume that there is some interferrence between that software and Access connection.
As far as I remember, I did invoke the PRISM software a while ago because with Access Connections, I was unable to switch on the wirless card (it was switched off for what reason ever ...
Thanks for any help!
jwka
When I start (one of my) Thinkpad (no LAN Cable attached), then I have no correct connection to the Network.
Browser fails, ping also.
Going into Thinkvantage Access Connections, press the button "disconnect" (I guess that is the label, I am using a German version labelled "trennen") and "connect" thereafter, everything works just fine.
Here is more info about the machine's symptons / settings:
1.) I use it with a fixed fix IP adress
2.) There is an icon in the tray saying "Data Frame Errors - Check WEP Settings." It seems to be the "AEIWLSTA.EXE" programm that I do not see on other TP's that I am useing and running with Access connections.
3.) When I run ThinkVanmtage Access Connections, it shows "all ok", the Wireless setting to be ok, 93 to 100% signal strength
4.) When i open this other icon, The "PRISM Wirelss properties" Programm opens and basically says very good connection etc.
What do I need to do to cure the problem? I assume that there is some interferrence between that software and Access connection.
As far as I remember, I did invoke the PRISM software a while ago because with Access Connections, I was unable to switch on the wirless card (it was switched off for what reason ever ...
Thanks for any help!
jwka