t43 m10 questions and fan disassembly questions

[Hans Gruber]

I have a minor problem that is annoying me. On the left side after putting in my M10 it doesn't seal properly. I removed the besel and put in my old besel from my original T43. I may post a picture. When I am typing on it you cannot tell anything is out of place. Does the M10 fit differently than the M24? The heatsink is bolted in and I am at a loss as to why it doesn't fit just right.

The last question. How do you take the fan off the heatsink on either the M24 or M10?

[lophiomys]

Sorry my answer wont be really helpful, because it is too long since I have fitted an M10 inside a T43.
IIRC I just had to remove and refit a bit of foam from the M10 to fit it properly inside and the bezel latches are a bit tricky on the left side.
But looking at the left side, the top bezel also shows a 1mm gap in the area of the M10. Didn't notice until now.
HTH

[Hans Gruber]

Sorry my answer wont be really helpful, because it is too long since I have fitted an M10 inside a T43.
IIRC I just had to remove and refit a bit of foam from the M10 to fit it properly inside and the bezel latches are a bit tricky on the left side.
But looking at the left side, the top bezel also shows a 1mm gap in the area of the M10. Didn't notice until now.
HTH

I have read your previous posts on the T43. I will post a pic of what my T43p looks like. There is a front snap that fits flush but a 1mm-2mm gap over the M10 fan.