Active Protection System and Ultrabay

[mat1458]

Hi,

Since using APS 1.32 (before I had a 1.2x version) my Ultrabay Disk stops too when shaking too much. Is there a way to disable APS for the Ultrabay only but leave it on for the main drive? I want to continue listening to MP3 while carrying my T42 in my backpack.

Or is there a way to download an older driver ?

Regards,
mat

[IAmTheEvilest]

I am not sure, but I think that with the new Software Installer, you can uninstall the newer version of APS and then use it again to install the older version back.

Try this...
http://img256.echo.cx/img256/7168/10jr.th.jpgLoad up the Software Installer and select next.

http://img256.echo.cx/img256/5589/21gx.th.jpgLeave the default setting for searching the drivers and click next.

http://img256.echo.cx/img256/4175/30wm1.th.jpgIf there is nothing to update, there won't be anything here. If you don't want to update anything, unselect it and select next.

http://img256.echo.cx/img256/7439/45qi.th.jpgLook for IBM Active Protection System and you'll notice that you can select the version. If the older version is available, select it.

http://img256.echo.cx/img256/4885/57dj.th.jpgThen check the box on the left and you might get a warning to backup. Then select Install.

I believe that doing so will let you "rollback" to your old driver.

Edited by Moderator: Links, not images, unless there's a warning in the subject line.