clear plate removal

Message

jsklar · #1 Post by **jsklar** » Sun Jul 17, 2005 1:40 pm

okay ... you can call me stupid or whatever but is there some kind of trick to removing and replacing the clear plates for the status indicators?

i just got 2668-C2U (super sweet btw) and added in a BMDC-3

i also ordered replacement clear plates but i can't seem to get them off to replace them...

help?

jfh · #2 Post by **jfh** » Sun Jul 17, 2005 2:07 pm

Did you look on the Levano site for the replacement instructions? I'll have to do this myself with one of my T43s when it arrives, but I suspect the details will be in the hardware repair guides.

JHEM · #3 Post by **JHEM** » Sun Jul 17, 2005 3:18 pm

If you've got the display assembly completely disassembled, you can push them out from the back openings for the LCDs and then simply peel them off.

If not, then use a razor blade or eXacto knife blade to pry up one corner and then gently peel it free.

Regards,

James

jsklar · #4 Post by **jsklar** » Sun Jul 17, 2005 9:34 pm

turns out all it took was using a nife to pry under the plate...i was just being a little too over careful with my new baby.

say, is the bluetooth light supposed to be green? is there way to replace it with a blue LED? would be much cooler...

emorphien · #5 Post by **emorphien** » Sun Jul 17, 2005 9:42 pm

It is green, don't know about replacing it but that should be possible.

clear plate removal

clear plate removal

duh

Who is online