Sysprepbackup Accessory Package? Do I need to install it?
Posted: Mon Nov 21, 2011 7:56 pm
I just upgraded from Rescue and Recovery 4.31 to 4.50 on my X201t which came with Win 7 Pro x64 and R&R 4.3 or earlier. I did the upgrade due to R&R 4.31 getting stuck at "gathering data...".
The 4.50 download page suggests I might need to run the Sysprepbackup Accessory Package, but I can't figure out whether I do or not. After the upgrade to 4.50 the Thinkvantage button worked normally during the boot up "ThinkPad" flast screen and launched R&R 4.50.
This is the paragraph I have found mystifying:
"•The Sysprepbackup operation changes in the Windows 7 operating system because a new version of Windows Recovery Environment (Windows RE) is built in the Windows 7 operating system. When you run the System Preparation Tool (Sysprep) and use the /generalize option, the Sysprep operation disables Windows RE by removing the Boot Configuration Data (BCD) entry to the Rescue and Recovery Pre Desktop Area (PDA). To make the Rescue and Recovery program work with Sysprepbackup in the Windows 7 operating system, you must download and install the Sysprepbackup accessory package."
from: http://support.lenovo.com/en_US/detail. ... IGR-4Q2QAK
Am I good to go without running the Sysprepbackup Accessory Package or should I run it even though nothing seems broken now?
Barry in Sheridan Wyoming
The 4.50 download page suggests I might need to run the Sysprepbackup Accessory Package, but I can't figure out whether I do or not. After the upgrade to 4.50 the Thinkvantage button worked normally during the boot up "ThinkPad" flast screen and launched R&R 4.50.
This is the paragraph I have found mystifying:
"•The Sysprepbackup operation changes in the Windows 7 operating system because a new version of Windows Recovery Environment (Windows RE) is built in the Windows 7 operating system. When you run the System Preparation Tool (Sysprep) and use the /generalize option, the Sysprep operation disables Windows RE by removing the Boot Configuration Data (BCD) entry to the Rescue and Recovery Pre Desktop Area (PDA). To make the Rescue and Recovery program work with Sysprepbackup in the Windows 7 operating system, you must download and install the Sysprepbackup accessory package."
from: http://support.lenovo.com/en_US/detail. ... IGR-4Q2QAK
Am I good to go without running the Sysprepbackup Accessory Package or should I run it even though nothing seems broken now?
Barry in Sheridan Wyoming