Hello,
Let me explain what happened before I got my problem. Windows XP froze up and I held onto the power button to shut it down.
When I tried turning it back on, the fan just runs and nothing happens, not even POST. I removed the battery and tried powering up with just the power adapter, the fan just spins and hums and that's it.
I took apart the thinkpad and followed the instructions here:
http://forum.thinkpads.com/viewtopic.ph ... t=inductor
But that inductor was not loose at all, I even tried to pull it out with my fingers. No loose connection there. I can try to resolder I suppose later this morning.
I'm hoping I'm close to fixing this. I tried to find other solutions, but I didn't find anything relevant.
T23 will not post, searched but no luck
Sounds similar to what happened to my T23... check out this thread http://forum.thinkpads.com/viewtopic.php?t=36170
Check all of the fuses on the board. They have Fx labels near them where x is a number. My problem is F2 is open when it should be close to zero ohms when measured with an ohm meter.
Check all of the fuses on the board. They have Fx labels near them where x is a number. My problem is F2 is open when it should be close to zero ohms when measured with an ohm meter.
-Steve
-
- Similar Topics
- Replies
- Views
- Last post
-
-
A20M type 2628 Boot/Post Failure
by Comatose152 » Wed Feb 01, 2017 8:22 pm » in ThinkPad R, A, G and Z Series - 4 Replies
- 1271 Views
-
Last post by RealBlackStuff
Thu Feb 02, 2017 7:17 am
-
-
-
SOLD: T61p 15.4" planar/systemboard post 08/08 1104A2 dated 256mb nVidia fx570m
by unixed » Thu Feb 02, 2017 7:25 pm » in Marketplace - Forum Members only - 2 Replies
- 552 Views
-
Last post by unixed
Sun Mar 19, 2017 9:38 pm
-
-
- 2 Replies
- 1119 Views
-
Last post by halap3n0
Wed Mar 15, 2017 8:29 am
-
-
FS: T61p 15.4" planar/systemboard post 08/08 1104A2 dated 256 MB NVIDIA FX 570M
by unixed » Sun Mar 19, 2017 10:44 pm » in Marketplace - Forum Members only - 0 Replies
- 285 Views
-
Last post by unixed
Sun Mar 19, 2017 10:44 pm
-
Who is online
Users browsing this forum: No registered users and 5 guests



