Thinkpads Forum

I've got lots of good movies on my T60 in .avi (or .mov or .mpg) that I sometimes watch on the T60's 15.4" widescreen, but I'd like to be able to watch them on the 23" LG display upon which I watch broadcast TV from my standalone receiver (LG 3410A) through a DVI connector. Is there some way to do that?

I have a docking station for the T60 which has a DVI connector, but it doesn't seem to work right.

Am I missing a driver? I'm running XP SP2 on the T60 (as well as ubuntu 9.04 in another partition).

Both the XP and ubuntu work OK with my Aver Volar USB stick receiver for HDTV. And, of course, I can watch those .avi movies just fine with, say, VLC on either OpSys.

It should work. What do you mean by "doesn't seem to work right"?

hello

i heve somme problem and i dont want to open a new post so i will do it here ...

i have a T60p and a docking station with a connector from DVI to HDMI but i cant force to work it witm my TOSHIBA 26" TV ... where could be the problem?

thx

Pretty much anywhere.

Question 1 - Can't get to work - what do you mean? No signal at all? Distorted picture? Wrong resolution?

Question 2 - Can you get it to work with a DVI desktop monitor?

Question 3 - Do you see the secondary monitor (TV) in the Windows resolution / display settings?

Q1 ... yes no signal at all ... even 1 blink

Q2 i dont have external monitor

Q3 no

but your question force me to think maybe i have a bad connector ... i bought a DVI-D to HDMI maybe thats the problem ?

Have you already tried connecting everything up, turn the TV on, and then boot the computer? I'm not sure it's true today, but back when I was messing around with this kind of set-up, it was necessary for the TV to be connected and on, before the computer was booted for it to detect the TV.

hahah it worked ... i just can f... belive that this call center tips still work sometimes ... when i restart computer it still doesnt work ... but when i rstart with duplication ON it finaly find the TV ...

thats great news for me THX for help ;]

I've done this in the past, only difference is using the 15pin VGA port.

1) plug a VGA cable into the 15pin port on your laptop and connect the other end to your TV
2) press FN+F7 to alter the display out to go to the TV, once you get that proceed with watching the movie

Pretty much the same process as connecting an external monitor

I don't have a docking station so have never been able to use a DVI output on a Lenovo laptop. Do you need to go the DVI route??

that everyone knows ... but how to force T60 to use DVI as a default output ? that is my question ...

The OS typically remembers the last output you used. If you run T60 on the dock all the time, using the DVI output, it will continue using it by default until you switch.