Page 1 of 1
T60: Some status indicators not working
Posted: Sun May 24, 2015 11:21 am
by kenwong
The problem I'm having with my T60 is quite similar to that of monacotaxi's in
here.
The power and AC power indicators stopped working a few days ago, although the AC power will still be on when the lid is closed. Now, the CapsLock indicator also doesn't work.
Any ideas or suggestions? Thanks in advance.
Re: T60: Some status indicators not working
Posted: Sun May 24, 2015 1:24 pm
by RealBlackStuff
Could be the inverter, or else a fuse near the LCD-connector on the motherboard.
Re: T60: Some status indicators not working
Posted: Sun May 24, 2015 2:44 pm
by eru3
Could also be the fault of LEDs, but unlikely. To confirm that just measure the voltage at specific LED when it should be on - if there is none or it is too low, that is fault elsewhere.
Re: T60: Some status indicators not working
Posted: Thu Aug 13, 2015 2:06 pm
by lmittell
I've had the same symptom once each on two different T60s. In both cases, the MB-to-display cable developed one or more open circuits. At some point, repeated cable flexing due to opening and closing the lid will inevitably cause failure.
HTH,
Larry
Re: T60: Some status indicators not working
Posted: Thu Aug 13, 2015 2:36 pm
by precip9
I have the same symptom on an X61. Replacing the inverter did not fix it. Inspection of the fuses revealed nothing. So I'd try a cable.
Re: T60: Some status indicators not working
Posted: Sun Jan 17, 2016 6:12 am
by kenwong
Hello,
Now only the WiFi led is working. Is it most possible that the inverter has gone bust? If so, how can I fix it? Would it be difficult?
Any help would be appreciated.