Take a look at our
ThinkPads.com HOME PAGE
For those who might want to contribute to the blog, start here: Editors Alley Topic
Then contact Bill with a Private Message


T60/T61 series specific matters only
Post Reply
Posts: 1
Joined: Wed Aug 07, 2019 9:37 pm
Location: Los Angeles, CA


#1 Post by katiequinn » Wed Aug 07, 2019 9:39 pm

charged the T60 batteries two days ago and I notice that the remaining capicity is still the same as the full charge capicity. I also have a X22. The remaining capicity of new X22 batteries droped about 1% or more everyday and the battery was charged at 95%. I am just wondering if the T60 charges the batteries immediately when the remaining capicity drops so the remaining capicity is always the same as the full charge capicity. How can I set the batteries to be charged at 95% of the full charge capicity? Thank you.

Posts: 1068
Joined: Fri Oct 11, 2013 7:45 pm
Location: North Ridgeville, Ohio, United States

Re: Battery?

#2 Post by theterminator93 » Wed Aug 07, 2019 10:45 pm

The built-in logic is usually set up to not charge unless it drops below 97 or 96 percent. The newer versions of Power Manager will let you set custom charge thresholds - for example (since I don't often need extended mobile runtimes) I set the battery charge thresholds on my T61 to charge up to 70%, but only if the charge dropped below 40%. I don't recall seeing a way do that with the versions supported on the X2* series though. If you want to keep the battery from being charged to 100% after a few days of self discharge you will likely need to remove it from the machine until you're ready to use it.
T480 | T25 | W520 i7-2860QM·Quadro 2000m·IPS FHD | T601F T9900·NVS 140m·LED AFFS UXGA
T420 IPS FHD | X220 IPS FHD | T61p·T61·43·42p|X220T·301·61T·41T·24·23·22|G41|A31p·22m|i1200|TransNote

Post Reply
  • Similar Topics
    Last post

Return to “ThinkPad T6x Series”

Who is online

Users browsing this forum: No registered users and 34 guests