Page 1 of 1
where exactly are the memory slots on the T60?
Posted: Fri Apr 28, 2006 12:27 pm
by jaybert
I've been searching around, and the best I can gather is that there is 1 slot underneath the palm rest, which means having to take the palm rest off to install it.
Where is the other one? Mine comes with 1 stick of 512mb, but my friend gave me his 2 sticks of 512mb out of his macbook, so I want to replace them both into the T60 so I can take advantage of the dual channel capabilities, which probably wont happen if I use the normal stick + 1 of the macbook's sticks.
Re: where exactly are the memory slots on the T60?
Posted: Fri Apr 28, 2006 2:08 pm
by Greg Gebhardt
jaybert wrote:I've been searching around, and the best I can gather is that there is 1 slot underneath the palm rest, which means having to take the palm rest off to install it.
Where is the other one? Mine comes with 1 stick of 512mb, but my friend gave me his 2 sticks of 512mb out of his macbook, so I want to replace them both into the T60 so I can take advantage of the dual channel capabilities, which probably wont happen if I use the normal stick + 1 of the macbook's sticks.
It is in the same place under the palm rest.
Posted: Fri Apr 28, 2006 2:15 pm
by jaybert
ah ok, so both slots are next to each other under the palm rest?
I was looking at the tech guide for replacing the memory, and from what the picture showed, it seemed that only 1 slot is there. Thanks for the info, now I can swap out the memory on Monday when the laptop should be coming in
Posted: Fri Apr 28, 2006 2:22 pm
by tselling
The slots are stacked or overlapped depending on how you want to look at it.. The good news is the palmrest is much easier to remove than on the T40 series (fewer screws and none with screw caps). Just remove the indicated screws on the bottom then pull up on the end closer to the keyboard (gently).
Posted: Sat Apr 29, 2006 2:04 pm
by jaybert
thanks, got the memory installed, wasnt very difficult at all. I didnt even have to disconnect the fingerprint reader.
Only issue I had was putting it back on, it wasnt sitting right at first, but I just kind of fanagled it around until it sat flush and screwed it back together.
Thanks for the info....never had to install memory in the T40 I had before. Why doesnt IBM just make a slot at the bottom of the laptop for easy access to the memory instead of having to remove the palm rest like every other brand?
Posted: Sat Apr 29, 2006 2:45 pm
by darrenf
jaybert wrote:Thanks for the info....never had to install memory in the T40 I had before. Why doesnt IBM just make a slot at the bottom of the laptop for easy access to the memory instead of having to remove the palm rest like every other brand?
This is how it was done on the T4x but that machine didn't have a magnesium roll cage along the bottom of the case. It has been theorized that the rollcage would be weakened if there were a large cutout in the bottom for RAM. I haven't personally confirmed that the rollcage runs along the entire bottom as it is, though.
Removing the palmrest is now a matter of removing just four screws -- not much work IMHO.
-darren