Battery Maintenance program kills my battery...
Posted: Wed May 02, 2007 8:36 am
I notice just recently that my battery's full charge capacity drops to a level of around 30-40 Wh which is far below its design capacity (56.16Wh). The battery is only one year old, so I decide to preform reset.
I opened the Battery Maintenance program and clicked "Perform Reset..." and continued my work. After around 1 hour, my T60 shut down like a sudden loss of power without any symptom, and the battery is simply dead after that:
1. I can't turn my T60 on with the battery only. Just nothing happens when pressing the power on key.
2. I turn my T60 on with AC adapter and battery. The remaining percentage of the battery is frozen at 96%, and the battery light keeps blinking.
2. Message Center gives a warning message: "Irreparable damage to the battery has been detected. Replace the battery with a new one. ", which is also shown when the mouse hovers the Power Manager Gauge icon.
Is there a way to rejuvenate my battery? It is a really unhappy experience that my first time battery maintenance ends up with a dead battery.
I opened the Battery Maintenance program and clicked "Perform Reset..." and continued my work. After around 1 hour, my T60 shut down like a sudden loss of power without any symptom, and the battery is simply dead after that:
1. I can't turn my T60 on with the battery only. Just nothing happens when pressing the power on key.
2. I turn my T60 on with AC adapter and battery. The remaining percentage of the battery is frozen at 96%, and the battery light keeps blinking.
2. Message Center gives a warning message: "Irreparable damage to the battery has been detected. Replace the battery with a new one. ", which is also shown when the mouse hovers the Power Manager Gauge icon.
Is there a way to rejuvenate my battery? It is a really unhappy experience that my first time battery maintenance ends up with a dead battery.