v5200 heat and information

T60/T61 series specific matters only
Post Reply
Message
Author
silver2002
Posts: 16
Joined: Thu Sep 13, 2007 9:15 am
Location: Sylmar, CA

v5200 heat and information

#1 Post by silver2002 » Thu Sep 13, 2007 6:40 pm

Just got a couple of questions about my T60p
What is the core clock speed of the v5200 ( my CCC says 128mhz)?
What is the Memory clock speed? (again mine says 135 mhz)
iam just trying to make sure these numbers r right any information would be help ful thx.

i also read on here that someone put a piece of copper on the gpu to keep it cool if any one knows what size should it be or where could i get one?

i already used arctic silver on my cpu and its running 3C lower on idle after 20 hours of use.
T60p-T2500, 100GB 7200 HDD, 2GB RAM, V5200, 14.1

RonS
Moderator Emeritus
Moderator Emeritus
Posts: 1374
Joined: Thu Dec 09, 2004 4:48 pm
Location: Portland, Oregon

#2 Post by RonS » Thu Sep 13, 2007 10:53 pm

Interesting...

I have a T60p/v5200 as well.

CCC reports core clock at 587 MHz
and memory clock speed at 693 MHz
Apathy is on the rise, but nobody seems to care.

silver2002
Posts: 16
Joined: Thu Sep 13, 2007 9:15 am
Location: Sylmar, CA

#3 Post by silver2002 » Thu Sep 13, 2007 11:43 pm

thx for your post RonS :D
i installed new drivers form ati website and not the lenovo ones and it reads

core 398Mhz
Memory 325Mhz

i guess i still have a ways to go to get your scores but iam guessing drivers r the problem
T60p-T2500, 100GB 7200 HDD, 2GB RAM, V5200, 14.1

killigrew
Freshman Member
Posts: 72
Joined: Mon Dec 11, 2006 11:36 am
Location: Germany

#4 Post by killigrew » Fri Sep 14, 2007 2:04 am

BIG LOL

just switch off Powerplay and you have full clock speeds!!!
btw Memory is the clock of the Grafics Memory....

cu :)

silver2002
Posts: 16
Joined: Thu Sep 13, 2007 9:15 am
Location: Sylmar, CA

#5 Post by silver2002 » Fri Sep 14, 2007 9:05 am

killigrew wrote:BIG LOL

just switch off Powerplay and you have full clock speeds!!!
btw Memory is the clock of the Grafics Memory....
i did turn off powerplay but my clocks were still that low until i got new drivers but thanks for your input

btw y r my clocks still slower than RonS if we have the same card?
T60p-T2500, 100GB 7200 HDD, 2GB RAM, V5200, 14.1

Pascal_TTH
Senior Member
Senior Member
Posts: 668
Joined: Sun May 28, 2006 7:17 pm
Location: Liege, Belgium, Europe
Contact:

#6 Post by Pascal_TTH » Fri Sep 14, 2007 4:17 pm

There are 3 frequencies level :

- Battery life (128/130 MHz) : 1390
- Balanced (324/130 MHz) : 1477
- Performances (400/320 MHz) : 3570

PS : mode (core/mem) : 3D Mark 2005


I replace the thermal pad by a copper plate (see topic about fan/heat T60). With no fan, the GPU idles at 66°C with power play set to battery life and at 70°C with GPU at performances.

I'am using the laptop for 4 hours with no fan running :

1 CPU 55°C (0x78)
2 APS 41°C (0x79)
3 PCM 42°C (0x7a)
4 GPU 66°C (0x7b)
5 BAT 50°C (0x7c)
7 BAT 34°C (0x7e)
9 BUS 43°C (0xc0)
10 PCI 49°C (0xc1)
11 PWR 50°C (0xc2)

While gaming, the GPU never hits 85°C. With fan at 3400 rpm, GPU max temp (during Oblivion) is about 83°C. With out the mod, GPU goes up until 95°C with the fan running at 3700 rpm.

PS : I use Thinkpad fancontrol to handle the fan speed.
Apple MacBook Pro MB133
T61p : Core 2 Duo T9300, Quadro FX 570m, 2GB CL4, 320GB, WUXGA
T60p : Core 2 Duo T7200, FireGL V5200, 2GB, 160GB, 14.1 SXGA+
T61 : Core 2 Duo T7300, Quadro NVS 140m, 2GB, 160GB, WXGA+

Retired : R61, T41p, T40p, X31, A31p, A30, X24, A21p, A20p

silver2002
Posts: 16
Joined: Thu Sep 13, 2007 9:15 am
Location: Sylmar, CA

#7 Post by silver2002 » Fri Sep 14, 2007 5:26 pm

Pascal_TTH your numbers are the same as mine :D
but RonS numbers are really high does he OC?

And about the copper piece what size is it or where did u get it because when i DOD:S my GPU Temp goes to 98 C i could really use that mod u did to cool it a little
T60p-T2500, 100GB 7200 HDD, 2GB RAM, V5200, 14.1

Pascal_TTH
Senior Member
Senior Member
Posts: 668
Joined: Sun May 28, 2006 7:17 pm
Location: Liege, Belgium, Europe
Contact:

#8 Post by Pascal_TTH » Sat Sep 15, 2007 10:29 am

silver2002 wrote:Pascal_TTH your numbers are the same as mine :D
but RonS numbers are really high does he OC?

And about the copper piece what size is it or where did u get it because when i DOD:S my GPU Temp goes to 98 C i could really use that mod u did to cool it a little

Hi silver2002,

You can read here about my mod : http://forum.thinkpads.com/viewtopic.ph ... &start=150

http://www.tt-hardware.com/img/news5/ne ... dujour.gif
The height is just the same as the masterpiece of the fan assembly.


RonS perhaps OC his GPU. Mine runs at stock freq.
Apple MacBook Pro MB133
T61p : Core 2 Duo T9300, Quadro FX 570m, 2GB CL4, 320GB, WUXGA
T60p : Core 2 Duo T7200, FireGL V5200, 2GB, 160GB, 14.1 SXGA+
T61 : Core 2 Duo T7300, Quadro NVS 140m, 2GB, 160GB, WXGA+

Retired : R61, T41p, T40p, X31, A31p, A30, X24, A21p, A20p

RonS
Moderator Emeritus
Moderator Emeritus
Posts: 1374
Joined: Thu Dec 09, 2004 4:48 pm
Location: Portland, Oregon

#9 Post by RonS » Sat Sep 15, 2007 10:48 pm

Sorry guys... I made a mistake

I took the numbers (above) from the V5200 card in the dock, rather than the internal V5200. Here are all of the numbers:

ATI MOBILITY FireGL V5200
Core Clock 398 MHz
Memory Clock 324 MHz

ATI FireGL V5200 (this is the card in the dock)
Core clock 587 MHz
Memory clock 693 MHz
Apathy is on the rise, but nobody seems to care.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “ThinkPad T6x Series”

Who is online

Users browsing this forum: No registered users and 26 guests