Page 1 of 1
T60, 2008VEP, IS CUDA POSSIBLE?!!
Posted: Mon May 03, 2010 8:59 pm
by Charlie.Brown
I was wondering if could swap out the ATI Radeon X1400 within for a CUDA enabled card. If so what is the highest end mobile processor possible?
Not 4 gaming. Linux 4 lyfe yo, or iATKOS depending on weather my birthday money comes through with enough for an Atheros based card. Moztly bruteforcing n shizz. Cuz I'm hardcore lyk that yo.
Re: T60, 2008VEP, IS CUDA POSSIBLE?!!
Posted: Mon May 03, 2010 9:17 pm
by ajkula66
You can't swap the card since it's soldered to the motherboard. What you can do is get a dock and install an additional card there.
The fastest CPU that T60 will take is T7600.
Re: T60, 2008VEP, IS CUDA POSSIBLE?!!
Posted: Mon May 03, 2010 9:50 pm
by Charlie.Brown
CUDA processing uses a GPU? Therefore a Nvidia card W/ processor embedded or no?
Re: T60, 2008VEP, IS CUDA POSSIBLE?!!
Posted: Mon May 03, 2010 9:56 pm
by ajkula66
OK, I don't think we're on the same wavelength here...
I understood your initial "mobile processor" question as a CPU one, therefore the answer I've given you.
Now, when it comes to graphics, do some research on Advanced mini-dock and what graphic cards it will take, I can't guide you there any further.
Re: T60, 2008VEP, IS CUDA POSSIBLE?!!
Posted: Wed May 19, 2010 8:08 pm
by Charlie.Brown
Perhaps explanation had been further elaborated, it would have looked something like,
Given that T60p laptop's contain mobile graphics processors or nvidia's trademark CUDA, to parallel CPU computing. I was just wondering if it was possible to swap out the existing graphics unit within my T60 for a nvidia card.
Re: T60, 2008VEP, IS CUDA POSSIBLE?!!
Posted: Wed May 19, 2010 8:13 pm
by ajkula66
You could throw in a T61/p motherboard in there, although I'd highly advise against it because of the high failure rate of nVidia chips of this generation.
Good luck.
Re: T60, 2008VEP, IS CUDA POSSIBLE?!!
Posted: Fri May 21, 2010 12:43 am
by tporter
ajkula66 wrote:You could throw in a T61/p motherboard in there
Only T61
p motherboard will support CUDA.
NVS140M installed on T61 doesn't support it due to 128MB memory.
Re: T60, 2008VEP, IS CUDA POSSIBLE?!!
Posted: Fri May 21, 2010 12:28 pm
by IvanAndreevich
If you just need it for development (not performance) there is a CUDA CPU emulator.
Re: T60, 2008VEP, IS CUDA POSSIBLE?!!
Posted: Fri May 21, 2010 10:34 pm
by ajkula66
tporter wrote:
Only T61p motherboard will support CUDA.
NVS140M installed on T61 doesn't support it due to 128MB memory.
That being the case, OP is out of luck since he can't fit a planar from a 15.4" WS T61p in his T60p, and 14" (4:3) models only had 128 MB VRAM even in "p" version...