Page 1 of 1

Adding Bluetooth To A T60

Posted: Sun Feb 06, 2011 8:32 pm
by Brian10161
Hi everyone,

I have an X60s with bluetooth, and was wondering if I could move the bluetooth card over to my T60 instead. The X60s is pretty much a write-off and I'm thinking I may part it out, but would like to salvage the bluetooth card if possible.

I have't confirmed it, but it looks like the bluetooth card goes in the LCD panel. I just want to confirm before I mess with it at all.

Thanks in advance,
Brian

Re: Adding Bluetooth To A T60

Posted: Mon Feb 07, 2011 2:53 am
by dr_st
The bluetooth card does go into the LCD and seems to be the same for T6x and X6x, however T60s that came without Bluetooth probably also come without a connector for the daughter card on the LCD cable. Which means you have to change the cable or solder a connector to it.

Re: Adding Bluetooth To A T60

Posted: Mon Feb 07, 2011 5:58 am
by Brian10161
Ah, good to know, maybe I will just use my little usb bluetooth adapter then. My T60 looks like it has never been opened, so I'll just keep it that way.

Thanks for the response.

Regards,
Brian

Re: Adding Bluetooth To A T60

Posted: Mon Feb 07, 2011 7:27 am
by underclocker
dr_st wrote:The bluetooth card does go into the LCD and seems to be the same for T6x and X6x, however T60s that came without Bluetooth probably also come without a connector for the daughter card on the LCD cable. Which means you have to change the cable or solder a connector to it.
FYI, upon occasion, the T60 and R60 models have the LCD cable with the connector even though they did not originally come with Bluetooth. You can check by removing the two screw covers and screws on the left front side of the LCD bezel and peaking underneath - if you see a vacant connector, you are good to go. Only one small screw is needed to secure the BT module to the assembly. No extra antennas or other parts are required. You can swap out the clear plate so you can see the BT icon illuminated when active, but this is not required. All T60's have the appropriate LCD inverter with the BT LED. You just install the BT adapter and then the Lenovo software. Add the clear plate, if desired. It's worth a peak.

Re: Adding Bluetooth To A T60

Posted: Tue Feb 08, 2011 11:38 am
by Kamika007z
By clear plate, he means the following:

http://cgi.ebay.com/Lenovo-Thinkpad-T60 ... 2a06d9bd83

If you do happen to perform this mod, and want the light indicator to also work for BT, just make sure you order the correct one that pertains to your model, i.e. 15" or 14", etc. :)

Re: Adding Bluetooth To A T60

Posted: Tue Feb 08, 2011 6:59 pm
by Brian10161
Cool, maybe this weekend or Thursday/Friday I will pop the bezel off and check.

Quite interested to find out :)

Re: Adding Bluetooth To A T60

Posted: Thu Apr 25, 2013 11:21 pm
by tomjrc
So? 2years later, what happened? did you get B.T.installed, was it hard to do? Thanks!

Re: Adding Bluetooth To A T60

Posted: Fri Apr 26, 2013 5:55 am
by RealBlackStuff
If you only need to put in the BT module, it takes about 2 minutes.
If you also need to swap the LCD cable, 20-60 minutes (depending on your skills).

Re: Adding Bluetooth To A T60

Posted: Wed May 01, 2013 8:31 am
by tomjrc
to replace the clear plate, do i just peel off the old one and stick down the new one ? thanks!

Re: Adding Bluetooth To A T60

Posted: Wed May 01, 2013 3:26 pm
by RealBlackStuff
yup.

Re: Adding Bluetooth To A T60

Posted: Sat May 18, 2013 10:44 am
by tomjrc
Well, I have looked for movie on replacing lcd cable but no luck!! Any help??

Re: Adding Bluetooth To A T60

Posted: Mon May 20, 2013 1:11 pm
by Peak2Peak
tomjrc wrote:Well, I have looked for movie on replacing lcd cable but no luck!! Any help??
Try here: Lenovo Service & Support Training - ThinkPad T60/T60p (RTD44) - Click on "Take Course" >>> "FRU Removals/Replacements" >>> "LCD or LCD Assembly"

Re: Adding Bluetooth To A T60

Posted: Mon May 20, 2013 2:08 pm
by tomjrc
thank you ,this site is very clear!!!