SSD Upgrade for T60p How-to? Need suggestions
Posted: Mon Apr 18, 2011 10:05 pm
Hi everyone,
I've come to acquire a used T60p with the following specs:
T7200
3GB DDR2
FireGL v5200
100 GB HDD (I think it's Hitachi Travelstar 7200 rpm)
SXGA+ screen
And I wish to upgrade it with an SSD. Here is my plan. Please leave feedback if you find any wrong.
- Buy a SATA Ultrabay Slim HDD Caddy (like this one)
- Buy a SATA II SSD (haven't decided on a brand name yet, could possibly go for Intel if I can get some discount)
- Remove the Hitachi HDD and replace it with the SSD
- Install Windows 7 32-bit and essential software/firmware
- Remove the optical drive from the Ultrabay
- Insert the Hitachi HDD and the caddy to the Ultrabay
- Enjoy
I searched the forum and saw some members have succeeded in upgrading to SSD, yet I found no specific instruction for this; hence, this thread.
I also saw a thread with similar intention but for T42 (http://www.thinkpads.com/forum/viewtopi ... =2&t=94452) and the OP suggested the 'CF to 44 pin 2.5" IDE' which I quite don't understand. Perhaps someone can enlighten me in this issue.
Thanks for reading.
I've come to acquire a used T60p with the following specs:
T7200
3GB DDR2
FireGL v5200
100 GB HDD (I think it's Hitachi Travelstar 7200 rpm)
SXGA+ screen
And I wish to upgrade it with an SSD. Here is my plan. Please leave feedback if you find any wrong.
- Buy a SATA Ultrabay Slim HDD Caddy (like this one)
- Buy a SATA II SSD (haven't decided on a brand name yet, could possibly go for Intel if I can get some discount)
- Remove the Hitachi HDD and replace it with the SSD
- Install Windows 7 32-bit and essential software/firmware
- Remove the optical drive from the Ultrabay
- Insert the Hitachi HDD and the caddy to the Ultrabay
- Enjoy
I searched the forum and saw some members have succeeded in upgrading to SSD, yet I found no specific instruction for this; hence, this thread.
I also saw a thread with similar intention but for T42 (http://www.thinkpads.com/forum/viewtopi ... =2&t=94452) and the OP suggested the 'CF to 44 pin 2.5" IDE' which I quite don't understand. Perhaps someone can enlighten me in this issue.
Thanks for reading.