I want to attach a Ugreen USB2 4 Port 10M active cable - it's effectively a 4 port hub on an active cable.
The hub is powered by a 2 Amp power supply.
There are three USB ports on the rear of the Ultrabase, but the active cable/hub is only recognised if it is plugged into the Ultrabase USB port nearest the right when facing the screen.
Other devices work when plugged into any of the three ports.
With the Ugreen and other devices plugged as above the laptop can be restarted and all devices connect.
The power supply is working and delivering 5V.
Any reason for this behaviour>
- Senior Member
- Posts: 546
- Joined: Sun Jan 24, 2010 5:32 pm
- Location: USA : Illinois : Chicago
You can try testing with ThinkPad firmware, if you do not have a different operating system handy. Try using a USB keyboard to navigate Setup, or just going up and down 'F12' list: does it work when hub is connected to all three of UltraBase's receptacles? Or you can attach a storage Stick and look for it in 'F12' boot source choice selection list.
I am not able to help you. I only bring this question where your problem exists, whether in hardware or in Microsoft Windows.
Following your suggestion, I formatted a memory stick to be bootable and tried it in all three USB ports.
In each USB port, under F12 the stick was listed every time as a bootable device.
I then tried all the combinations of the 4-port cable, a USB-to-Serial cable, in all three USB ports.
I couldn't fault the USB ports.
I also tried an inline voltage/current/resistance USB dongle on all three ports, again all seemed okay.
Tonight I tried again, having undocked and redocked the X41.
This time the USB port nearest the left was dead - the USB voltage dongle didn't power up, suggesting to me no USB volts from that port.
So I'm wondering if there's an intermittant inside the dock.
When I dock my T410, about 10% of the time the mouse does not get power, and about 30% of the time the keyboard does not get power. Undocking/redocking, or even just wiggling the laptop around the connector a bit solves the issue after 1-3 attempts.
Collectibles: T430s (IPS FHD + Classic Keyboard), X32 (IPS Screen)
Retired: X61 7673-V2V, T60 1952-F76, A31p w/ Ultrabay Numpad
1) Boot up with Hub in port 1, USB-to-Serial in port 2, port 2 is dead.
Move USB-to-Serial to port 3, it works.
2) Next boot, USB-to Serial in port 3 does not power up.
Move USB-to-Serial to port 2, it works.
etc, ad nauseam.
- Similar Topics
- Last post
[LENOVO THINKPAD T420s] Completely erratic behaviour of my laptop (random crashes and random boots)
Last post by turomini « Sun Apr 01, 2018 1:07 pmReplies: 3
Posted in ThinkPad T400/410/420 and T500/510/520 Series
- 3 Replies
- 1550 Views
Last post by turomini
Sun Apr 01, 2018 1:07 pm
- 2 Replies
- 806 Views
Last post by SumGuy
Sun Mar 25, 2018 7:52 am
- 2 Replies
- 361 Views
Last post by Blzut3
Wed Feb 07, 2018 12:38 am
- 0 Replies
- 154 Views
Last post by mugenn
Sun May 13, 2018 2:26 pm
Who is online
Users browsing this forum: Bing [Bot] and 10 guests