Question for X60T MultiTouch owners
Posted: Wed Sep 26, 2007 5:54 pm
I sent back my X60T in the first week of August to get the latch fixed. I received it three weeks later and not only was the latch not fixed, but they messed with the LCD and there is now yellow backlight bleeding if any pressure is put on the lcd. I would like to confirm that my X60T was damaged while being repaired and that this yellow backlight bleeding is not normal. I sent it in again and the same result, nothing was fixed. Finally sent it to a "specialist" and they fixed the latch but the LCD was yet again in worse condition, this time it had both the yellow backlight bleeding and the bezel is indented in three parts of the screen edge(like it wasn't assembled correctly).
It is most prevalent when there are no other light sources in the room and the background is black. If you put any pressure on the sides of the lcd (where there is plastic, not directly on the screen), do you get any yellow backlight bleeding? This goes for around the entire screen, but I get the worst bleeding when it is on the right side (the backlight actually turns the vast majority of my lcd yellow, with the brightest yellow being closest to the point of pressure).
If anyone would like pictures of what I am talking about I may be able to get some by borrowing a camera from a friend.
Thank you for any input.
It is most prevalent when there are no other light sources in the room and the background is black. If you put any pressure on the sides of the lcd (where there is plastic, not directly on the screen), do you get any yellow backlight bleeding? This goes for around the entire screen, but I get the worst bleeding when it is on the right side (the backlight actually turns the vast majority of my lcd yellow, with the brightest yellow being closest to the point of pressure).
If anyone would like pictures of what I am talking about I may be able to get some by borrowing a camera from a friend.
Thank you for any input.