Page 1 of 1
Running a Dell 3008WFP from a T61 Type 6460-07U
Posted: Sat Mar 05, 2011 3:03 pm
by davidschultz
I just got a Dell 3008WFP off Ebay. I have a T61 without a DVI docking port. I connected a VGA cable to the monitor and can't figure out how to get an image on it. The monitor has a screen saver window that says No DVI-D1 Cable. Can I run the monitor at all without a docking port? At this point I don't need max resolution.
David
Re: Running a Dell 3008WFP from a T61 Type 6460-07U
Posted: Sat Mar 05, 2011 3:34 pm
by dr_st
There should be a way to select the video input (DVI, VGA) either through the monitor menu or using one of the buttons on the front panel.
Re: Running a Dell 3008WFP from a T61 Type 6460-07U
Posted: Sat Mar 05, 2011 3:36 pm
by Neil
Welcome to the forum! Here's a quote from the Dell Support Website:
Support VGA, DVI-D, DisplayPort, HDMI, Component, S-Video and Composite video signals.
So, looks like you should be able to connect directly from the VGA port without a dock. Does the monitor have a hardware or software switch to choose inputs? And do you have the VGA port active on the T61? Toggle Fn + F7 to switch between LCD, VGA and VGA+LCD.
Re: Running a Dell 3008WFP from a T61 Type 6460-07U
Posted: Sat Mar 05, 2011 7:14 pm
by davidschultz
Hi Neil, Thanks you fixed the issue. I figured out the controls on the monitor and got it to work .
Thanks Again,
David
Re: Running a Dell 3008WFP from a T61 Type 6460-07U
Posted: Mon Mar 07, 2011 2:59 am
by IvanAndreevich
davidschultz wrote:Hi Neil, Thanks you fixed the issue. I figured out the controls on the monitor and got it to work .
Thanks Again,
David
You won't be able to use that monitor properly like that. It requires a DUAL LINK DVI cable for 2560x1600 to work. Get the right dock (for example -
http://www-307.ibm.com/pc/support/site. ... 61297.html) and enjoy it fully. I love my 3007WFP.
Re: Running a Dell 3008WFP from a T61 Type 6460-07U
Posted: Mon Mar 07, 2011 1:03 pm
by davidschultz
Hi Ivan, Thanks for the link. I understand I can't get max resolution with my setup. I just wanted to make sure the monitor worked. I now have a problem that resulted from my trying to adjust the resolution color brightness, etc.. I made some changes and clicked apply and the screen went blank and now says it isn't getting a signal from my T61. Haven't figured that out yet.