Page 1 of 1

Fresh out of Box X200s (WXGA+ / LED) issue

Posted: Wed Sep 09, 2009 8:56 pm
by benjet
I have something weird on my fresh out of the box X200s (with LED based WXGA+ screen)

While actively using the computer the screen seems to go into a battery conserve mode - screen goes form full bright to 1 bar of brightness - OSD shows the same, then within seconds it returns to normal. This looks as if it were a power mgmnt issue but it's occuring while I'm typing, scrolling, etc. not when it's supposed to be (when it's not being used).

Happens every few minutes, and it's mighty annoying.

Any ideas?

Re: Fresh out of Box X200s (WXGA+ / LED) issue

Posted: Wed Sep 09, 2009 10:30 pm
by ZaZ
Did you check the timers in Power Manager?

Re: Fresh out of Box X200s (WXGA+ / LED) issue

Posted: Thu Sep 10, 2009 12:10 am
by benjet
FredGarvin wrote:Did you check the timers in Power Manager?
I have, and will do so again, but there would have to be a setting in milliseconds as it literally happens while I'm typing.

Re: Fresh out of Box X200s (WXGA+ / LED) issue

Posted: Thu Sep 10, 2009 1:12 am
by ZaZ
My R60 was dimming the screen too after a few minutes. Turning off dim screen in the Power Manager timers section fixed it. I'm not sure if your issue is the same.

Re: Fresh out of Box X200s (WXGA+ / LED) issue

Posted: Mon Sep 14, 2009 2:20 am
by benjet
All settings were on max performance still only occurs on battery power and while actually typing/scrolling, not pausing.

Full bright to full dim and back in 1.5 seconds.