Page 1 of 1
t410 esata port performance eSATA I, eSATA II or eSATAIII ?
Posted: Thu May 03, 2012 7:05 am
by rychuu
Hello,
What is the measured performance (speed) of the t410 eSata port ?
I am thinking is has sense to buy a 'highspeed' SATA III 6gb cables?
best regards
Re: t410 esata port performance eSATA I, eSATA II or eSATAIII ?
Posted: Thu May 03, 2012 4:41 pm
by Kaze22
Esata is always Sata2
Re: t410 esata port performance eSATA I, eSATA II or eSATAIII ?
Posted: Sat May 05, 2012 4:21 pm
by rychuu
Kaze22 wrote:Esata is always Sata2
thank you for the reply
Should I expect performance similar to this: (blue line)
or more??
?
regards
Re: t410 esata port performance eSATA I, eSATA II or eSATAIII ?
Posted: Sun May 06, 2012 12:20 am
by Kaze22
I've never gotten anymore than 250mb transfer rate out of my esata, but then again, it all depends on your source and input drives.
In order to maximize the esata connection, you need to have two SSDs that can both do over 300mb read and write, only then can you saturate the esata bandwith.
I've never had 2 drives fast enough to do a transfer that would maximize the esata connection, the most I've ever seen out of esata was 250mb sustained write.
Going from a 8 Bay Raid to an SSD.
I wouldn't waste my money getting an Sata 3 Esata Cable, because current generation esata connection do not come close to sata 3 transfer rates.
Its very likely that the next revision of esata will be Sata 3 and possibly beyond, maybe even Thunderbolt speeds.
Re: t410 esata port performance eSATA I, eSATA II or eSATAIII ?
Posted: Sat May 19, 2012 9:03 am
by rychuu
ttthanks for your replies
iam thinking about bying a ssd drive. What speed should i expect for tthe intternal disk connector?
i have found esata III controller on ebay with Marvell chip.
what is the performance of the epresscard interface in t410?
i havee read about 5Gbit. it is lower than sataIII specification(6Gbit)