T410s RAM upgrade problem
Posted: Sat Jan 14, 2017 9:22 pm
i just bought a T410s Core i5 2.4Ghz Win7 Pro and have been doing the usual upgrades (SSD and RAM) but I just hit a snag with my ram upgrade.
The computer came with 2x2 DDR3 PC8500 sticks (with the 8 modules on the top) and I purchased a 2 x4 8 GB ram kit online and did the usual steps of replacing the RAM sticks. When I powered the computer on, there was no display at all and the computer was unresponsive. It didn't even make it to the thinkpad screen to boot into BIOS. I replaced my old sticks and the computer booted up fine. I went into BIOS to try and see if there was any default resets for memory I could use but no dice. Just tried my 2x4 sticks again but still straight to black display...
Looking for advice and direction to help me in the right direction to see if it's the RAM sticks bring faulty or whether there is some hardware/software setting that is preventing me from using the new RAM.
For reference, this is the RAM I bought:
2x4 1066 MHz NonECC 512x64 SoDimm DDR3 PC8500 - Samsung K2SD3/4G106SB
Thanks in advance for everyone's help!
The computer came with 2x2 DDR3 PC8500 sticks (with the 8 modules on the top) and I purchased a 2 x4 8 GB ram kit online and did the usual steps of replacing the RAM sticks. When I powered the computer on, there was no display at all and the computer was unresponsive. It didn't even make it to the thinkpad screen to boot into BIOS. I replaced my old sticks and the computer booted up fine. I went into BIOS to try and see if there was any default resets for memory I could use but no dice. Just tried my 2x4 sticks again but still straight to black display...
Looking for advice and direction to help me in the right direction to see if it's the RAM sticks bring faulty or whether there is some hardware/software setting that is preventing me from using the new RAM.
For reference, this is the RAM I bought:
2x4 1066 MHz NonECC 512x64 SoDimm DDR3 PC8500 - Samsung K2SD3/4G106SB
Thanks in advance for everyone's help!