Page 1 of 1

T500 integrated graphic shuts off after reassembly

Posted: Tue Aug 27, 2019 3:27 am
by matthewbartlett
so I have a T500 with switchable graphics. It had some processor, i switched it with different one from different T500 applied paste etc. After boot it shuts down while loading OS or before, I have to remove battery, replug in order to make it turn on again. This doesn't happen on discrete graphics though. I switched its stock processor back, applied paste, same problem. So I don't get what could have happened. Basically I returned the hardware setup back to stock and it still has the problem. So I am forced to run it in discrete mode all the time which is quite an energy hungry way.

Re: T500 integrated graphic shuts off after reassembly

Posted: Tue Aug 27, 2019 4:47 am
by RealBlackStuff
Check the BIOS/Config/Display settings.