Page 1 of 1

Centrino 6300 wont work properly after restore

Posted: Thu Sep 22, 2011 12:32 am
by markgca
i have a t420s with a centrino 6300 agn wireless card.

i restored my system from a backup (a mistake...) and now the wireless function doesnt work.

under device manager the card/driver seems to be installed properly. but the card wont connect to any networks. it does see them however, just wont connect.

any ideas?


mark

Re: Centrino 6300 wont work properly after restore

Posted: Thu Sep 22, 2011 2:15 am
by virge
I don't know if I can help, but some more information would be helpful:

1. What happens when you try to connect to a wireless network? Any error messages?

2. Have you tried connecting to an unencrypted network?

Re: Centrino 6300 wont work properly after restore

Posted: Thu Sep 22, 2011 7:47 am
by markgca
very good suggestions.

i got it working.

turned out on reinstall, the drivers had an option to connect to the access point even if the ssid wasnt broadcast; this defaulted to off, and it needed to be on.

working again! thanks for the ideas

mark