Any clues how I did this?

[waterloo]

I swear I didn't drop it

Pictures of the piece
http://imgur.com/JbNvyhG
http://imgur.com/hWyjmSA
http://imgur.com/b7wfFjU
http://imgur.com/ipYPVsE <-- hook is still there so the piece isn't "loose"

Close ups with the piece in
http://imgur.com/tnA5Zbl
http://imgur.com/9vjsPv2

Close ups without the piece
http://imgur.com/iCE8u11
http://imgur.com/IZa2zDE

Thanks

[waterloo]

https://forums.lenovo.com/t5/W-Series-T ... -p/1176713

This guy has it on a W530 (same spot but crack is smaller).

- The W520 & W530 seem to use the same FRU for the LCD Bezel (60Y5482) & hinge (60Y5485)
- Each hinge gets two screws per side with same screw type & torque spec



Maybe this was due to factory defective left hinge install or hinge itself that I somehow made worse?

So then just fixing the LCD bezel wouldn't be enough right?

[RealBlackStuff]

To me it looks like the left bottom screw, which only holds the bezel in place, was over-tightened.
OR the bezel is mis-constructed on the inside. Maybe it needs a washer between bezel-hole and screw stud.
Either glue the pieces together, or replace just the bezel and be careful when putting in the screw.