I netted three screws from this adventure, the one that was stuck on the I/O daughter board and one long case screw. Apparently I put one short screw inside in the wrong hole there (near RJ-45), so now the long one doesn't fit. There were no threads in the hole the small one was supposed to go.
And also one short screw that I had in the bucket of case screws. I couldn't find where that one had to go, lol. The other three short ones sit under the battery, the fourth?
Anyway, I'm happy it's back up and running, so for now I'm happy and I'm not going to take it apart again.
Haha, BIOS 1.16 also means the RAM is running at 1600





