T42p UXGA in Intel GMA910 R52

[abodah]

Hello All,
New to this forum, and hoping to find solution for an old problem.
I searched for it in this forum and other site, but the topics was old with no solutions.
I had a broken T42p with a good LCD panel. and I recently bought an R52 with XGA display and Intel GMA 910.
I fitted the UXGA display in the R52, but the screen was either shifted to the right, or scaled up horizontally.
Now I tried EDID override, Cable change, and software's like PowerStrip.. nothing solved my problem.
I read somewhere that the Intel's cards do not support EDID override.
I am searching for a solution and your help - if you can - is much appreciated.
Also, I am thinking about EDID chip reprogramming, would that do the trick?
Regards
abodah

[RealBlackStuff]

A T42p UXGA panel will only work in an R52 if it has ATI graphics.
You also need an UXGA-capable LCD-cable, which does not exist for R52.
On R52 Intel it will never work.

[kfzhu1229]

Now I tried EDID override, Cable change, and software's like PowerStrip.. nothing solved my problem.

I think EDID override only works with T/X/R6x series as they share the same screen cable.
You really should get a T43/R52 board with ATI. Intel GMA not only refuses any screen but XGA, but also it does not support any kinds of Windows Aero. There are plenty avail on eBay

[ajkula66]

A T42p UXGA panel will only work in an R52 if it has ATI graphics.

Correct.

You also need an UXGA-capable LCD-cable, which does not exist for R52.

A cable from an UXGA R50p should solve this part of the problem...

On R52 Intel it will never work.

...but you're back to square one right here.