How to eject SD card on Z60t?

R, A, G and Z series specific matters only
Post Reply
Message
Author
xinvar
Posts: 2
Joined: Tue Jul 25, 2006 8:39 pm
Location: USA

How to eject SD card on Z60t?

#1 Post by xinvar » Wed Jul 26, 2006 8:35 am

Hi, I know this is a dumb question. But after I inserted a SD card into the Z60t sd card reader, I couldn't get it out! Usually in other SD card reader (like one in a digital camera) I would push the SD card further and it will pop out, but it's not the case here. Finally I used forceps to get it out.

- xinvar

daveman
Posts: 16
Joined: Tue Jul 18, 2006 12:28 am
Location: USA

#2 Post by daveman » Wed Jul 26, 2006 10:20 am

It's the same way, it's just tough. Push it in and it'll pop out ever so slightly.

o1sowise
Freshman Member
Posts: 120
Joined: Fri Dec 02, 2005 8:55 am
Location: Wayne, NJ, USA
Contact:

#3 Post by o1sowise » Wed Jul 26, 2006 11:43 am

I had the same question. It's not very obvious. :shock:

You push it in a little and it pops out a little (pop is not the right word). Then I usually lift the laptop up off the desk so I can get a good grip on the card (assuming I didn't just trim my fingernails). :wink:

xinvar
Posts: 2
Joined: Tue Jul 25, 2006 8:39 pm
Location: USA

#4 Post by xinvar » Fri Jul 28, 2006 8:54 am

I couldn't believe such a bad design happened in Thinkpad... Mine doesn't pop (or move) at all when pushed.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “ThinkPad R, A, G and Z Series”

Who is online

Users browsing this forum: No registered users and 4 guests