Page 1 of 1
OVERCLOCKING A CELERON MMC2 IN 600E
Posted: Mon Jun 13, 2005 9:50 am
by Laptop_wizard
Hey guys, dose anyone know how I can overclock a cleron 500MHz MMC2
CPU, Cause you guys are like really knowledgeable.
also, if i where to solder a 1k ohm resistor to a P3 cpu, what exackly has to be done to protect the cpu, what are the exzact steps.
Thanks A ton.
Posted: Tue Jun 14, 2005 3:44 am
by Katch
*sigh*
http://www.xabk.co.uk
All the information is here, as I've pointed out to you a number of times. If you still are having difficulty understanding the process of overclocking the TP600e through hardware mods or enabling higher clockspeeds on speedstep enabled P3s, then these mods are not for you.
You don't solder a 1k ohm resistor to the CPU, you solder it to the motherboard of the laptop. You only solder a resistor (2.2 k ohm) to P3 CPUs to enable the higher clockspeeds through speedstep.
Posted: Tue Jun 14, 2005 11:11 am
by Laptop_wizard
Hey catch, and thankyou very much for your reply, Thanks allot I understand now, i thaught you had to solder to the cpu.
so if I actaully solder a 2.2k to the P3 cpu, I'll get more then 500MHz?
Sorry
thanks