Page 1 of 1
TP600 'mouse' button going bad
Posted: Fri Jun 25, 2004 6:32 pm
by Guest
The left 'mouse' button on my TP600 is going bad. I first noticed that it didn't always work when I pressed it, then noticed it didn't 'click' like the right button. I popped off the button and found that the rubber on the switch was wearing out and torn about 3/4 of the way around the perimeter. Are these replacable at all? Any other suggestions? TIA
Re: TP600 'mouse' button going bad
Posted: Fri Jun 25, 2004 6:49 pm
by G-Man
Replacable. Look up the part number
here, and call IBM, or check Ebay.
Regards,
G-Man
Posted: Fri Jun 25, 2004 7:21 pm
by Guest
You mean replace the entire keyboard? Sure, I could do that. I'm wondering if there is anything that can be done about the one mouse button without replacing the entire keyboard. Thanks!
Posted: Sun Jun 27, 2004 8:39 pm
by Guest
You could set your mouse in windows to "left handed", and use the other buton.