Page 1 of 1

Z380 Suspend Mode?

Posted: Sat Dec 24, 2005 2:29 pm
by ThinkAgain
The Z380 that I inherited was used in wireless mode, with a CardBus Ethernet PCMCIA Card. The battery is dead. I had been running the Z380
with an adapter, when all of a sudden it slowly shut down on me, and I
couldn't re-start it...

The Suspend Mode Indicator Light stays on--does this mean the Z380
settings cause it to shut down like that? If so, how do I get it running again?

Or did the machine just die out completely?

Thanks for any replies!

Posted: Sat Dec 24, 2005 4:57 pm
by AlphaKilo470
If it's in suspend mode you should be able to wake it up either by hitting the FN key or shutting the lid and re-opening it.

If you can't wake it up, since there's no battery, you should be able to just pull the plug for about 5 or 10 seconds then be able to power the machine on again after plugging it back in.

I also believe there might be some stuff aboutthis stashed away in the FAQ.

Posted: Wed Dec 28, 2005 7:23 pm
by ThinkAgain
I turned the 380Z on again, but it shut down yet again. The Green Suspend Mode Indicator Light stays on.

None of those remedies work, and I can't get into Power Management to change any settings when the machine won't stay on long enough....