Do I *HAVE* to reformat and install fresh???
Posted: Mon May 10, 2004 9:55 pm
Okay, here's the deal. I had a plain 770. Worked fine, if a bit slow these days with WinXP. I bought a 770x, I put my hard drive in it and figured I'd just have to tweak a few things... not working that way. The sound is non-op and the dsp shows an unknown audio device under it, the infrared isn't working right and the parallel port is also non-op.
The most maddening part is that I can make the manual configuration changes to fix some of these but it says the firmware won't give them the required resources on reboot. With the audio the crystal driver wants an I/O range that the motherboard is using and it won't let me manually change it. I had hoped that maybe installing XP again over the current install might fix these things but they are still there.... any ideas?
The most maddening part is that I can make the manual configuration changes to fix some of these but it says the firmware won't give them the required resources on reboot. With the audio the crystal driver wants an I/O range that the motherboard is using and it won't let me manually change it. I had hoped that maybe installing XP again over the current install might fix these things but they are still there.... any ideas?