need to reset thermal sensor of 390E 390X desperatly!
Posted: Wed Sep 30, 2009 11:17 am
hallo,
when i use my 390E, 2626 BOG, it works normally, but after few minutes goes to freeze automatically without any fan action. the fan does work when i boot pc, but doesn't work during the normal use; it just work very very very slowly. ( i put a cigarette near the fan air exit hole and i saw the smoke pushed away but i cannot hear the noise of fan action
)
after pc doctor diagnostic test results : fan test failed.
i red hardware maintence manual and it describes exatly my problem, and says that i've to reset my thermal sensor with Hardware maintence disck named "ce utility diskette". i know that the file to obtain the executable diskette is named "ceutq103.exe" but i didn't find it anywhere ;i found with google an old ibm site, i think, with "ceukq110.exe" and "ceutb111" but they don't work with my system neither 390E nor 390X and, here the moderator closed my previous thread because the HMD is a IBM/LENOVO propertary disk so we cannot share or what else so i cannot ask it in THIS site/forum!.
So..somebody can help me to reset my thermal sensor even WITHOUT HMD ?
there is some program/software that can help me for this issue?
the best should be getting HMD ceutq103 ..but as i said i cannot ask it so it's a impossible mission to reset thermal sensor?
thankyou to all
p.s.:i have no problems with heatsink or grease pad (there's not grease to put)
p.s.: i hope that this time moderator will not close this thread just because as i specify more times I'M NOT ASKING THE HMD or about to get it! because i know that i cannot ask it or he'll close again the thread! (are the site's rules as he wrote)
when i use my 390E, 2626 BOG, it works normally, but after few minutes goes to freeze automatically without any fan action. the fan does work when i boot pc, but doesn't work during the normal use; it just work very very very slowly. ( i put a cigarette near the fan air exit hole and i saw the smoke pushed away but i cannot hear the noise of fan action
) after pc doctor diagnostic test results : fan test failed.
i red hardware maintence manual and it describes exatly my problem, and says that i've to reset my thermal sensor with Hardware maintence disck named "ce utility diskette". i know that the file to obtain the executable diskette is named "ceutq103.exe" but i didn't find it anywhere ;i found with google an old ibm site, i think, with "ceukq110.exe" and "ceutb111" but they don't work with my system neither 390E nor 390X and, here the moderator closed my previous thread because the HMD is a IBM/LENOVO propertary disk so we cannot share or what else so i cannot ask it in THIS site/forum!.
So..somebody can help me to reset my thermal sensor even WITHOUT HMD ?
there is some program/software that can help me for this issue?
the best should be getting HMD ceutq103 ..but as i said i cannot ask it so it's a impossible mission to reset thermal sensor?
thankyou to all
p.s.:i have no problems with heatsink or grease pad (there's not grease to put)
p.s.: i hope that this time moderator will not close this thread just because as i specify more times I'M NOT ASKING THE HMD or about to get it! because i know that i cannot ask it or he'll close again the thread! (are the site's rules as he wrote)
