Page 1 of 1
Keep high or low density 64mb ram? for 600e?
Posted: Thu Dec 03, 2009 11:17 am
by kocoman
I have a 600e with
32mb low density (4 pcs) - built in
64mb low density (8 pcs total) - added
64mb high density (4 pcs total) - added
I want to expand my memory, so I have to remove one of them but which 64mb ram should I keep?
thanks
Re: Keep high or low density 64mb ram? for 600e?
Posted: Thu Dec 03, 2009 5:41 pm
by Unknown_K
If they both currently work I don't think it matters unless one is a CS2 (faster) rating.
Re: Keep high or low density 64mb ram? for 600e?
Posted: Thu Dec 03, 2009 5:54 pm
by paul*robertson
You could also try upgrading the hard drive if you are after more speed.
Re: Keep high or low density 64mb ram? for 600e?
Posted: Thu Dec 03, 2009 6:00 pm
by Neil
My recommendation would be to take both 64MB sticks out, and put two 128MB sticks in it. That's the way we run our 600E.
Re: Keep high or low density 64mb ram? for 600e?
Posted: Thu Dec 03, 2009 11:47 pm
by rkawakami
kocoman wrote:I want to expand my memory, so I have to remove one of them but which 64mb ram should I keep?
I'd pull the "high density" (4 chips on the board) module since the system is probably only seeing 32MB worth. 600E systems can take low density 256MB modules so if cost is not an object, then pull BOTH 64MB modules and install at least one 256MB module.