Page 1 of 1

T440p not turning on after clunkpad replacement

Posted: Sun Jun 14, 2020 5:33 am
by ist
Hi,

Finally decided to change my clunkpad. Disassembly went mostly fine. I had some trouble with the palmrest snaps on the power button side. When I reassembled everything I couldn't turn it on. No lights, no fans spinning. Disassembled it again and checked if something plugged off but there was nothing obvious to see. What could go wrong? Maybe I broke the power-button card?

Thanks.

Re: T440p not turning on after clunkpad replacement

Posted: Wed Jul 22, 2020 7:01 am
by whatsuphelpline
I'm no expert here but there is a blue cable and clamp just below the power button, is that still intact? That's the first thing I can think of. Not even sure whether that is power related though.