track point sensitivity

Message

ennma · #1 Post by **ennma** » Fri Jun 22, 2007 6:54 pm

Hello all,
I have maxed out my track point settings, and still i feel it is sluggish. any suggestion on how to increase the mouse speed/sensitiviy.

thanks

ennma

#2 Post by **Kyocera** » Fri Jun 22, 2007 7:50 pm

uncheck - enhance pointer precision.

ennma · #3 Post by **ennma** » Fri Jun 22, 2007 8:14 pm

thanks, still feel sluggish, i think its just me.

thanks alot though

ennma

larrys · #4 Post by **larrys** » Mon Jun 25, 2007 8:41 am

The following may work for you...go to:

Display Properties
Settings
Advanced
Monitor

and increase the screen refresh rate. From what I read in posts here, this setting has no impact on the LCD monitor, but it does increase the track point sensitivity. I set it at 85 and am happy with that.

ennma · #5 Post by **ennma** » Tue Jun 26, 2007 4:31 pm

I cannot increase the refresh rate of my screen, should I be?

thanks

larrys · #6 Post by **larrys** » Wed Jun 27, 2007 8:31 am

ennma wrote:I cannot increase the refresh rate of my screen, should I be?

Is there a check in the box for "Hide modes that this monitor cannot display"? If so, uncheck the box and you should see some additional refresh rates. Again, this should only be done for the LCD screen. Not recommended for CRTs.

ennma · #7 Post by **ennma** » Wed Jun 27, 2007 10:27 am

Hi
First of all , sorry, I was asking this for my T60 lcd , oopps should have made that clear. so unchecking the "hide " only shows the different resolution.

thanks.

ennma

dr_st · #8 Post by **dr_st** » Wed Jul 04, 2007 9:23 am

There are two places where you control trackpoint speed:

Control Panel -> Mouse -> Pointer Options -> Select Pointer Speed

Control Panel -> Mouse -> Ultranav -> Trackpoint -> Sensitivity

Mine is set exactly at the middle at "pointer speed" (enhance precision is turned ON), and two bars below max at "sensitivity".

If you maxed both out and it stills feels sluggish, then either your trackpoint is defective, or you just don't know how to use it right.

ennma · #9 Post by **ennma** » Wed Jul 04, 2007 9:28 am

no, Its me, I adapted to the speed, on my 14" sxga+ i travel diagonal diagonal in 0.6 seconds, and people who have recently used my laptop complains of not being able to see the pointer.

so I am defective

.

thanks

ennma

steveg47 · #10 Post by **steveg47** » Wed Jul 04, 2007 9:31 am

You might try going directly to the Synaptics website and downloading the latest drivers directly from there. I've had excellent results from my trackpoint and touchpad using Synaptics drivers.
http://www.synaptics.com/support/drive.cfm

track point sensitivity

track point sensitivity

Who is online