Page 1 of 1
Xandro
Posted: Mon Oct 25, 2004 9:09 am
by allthewayaj
People: I just recently bought Xandro off the net, but when I go to install it in my TP 600e, all it does is print number after number,,,, no installation!!!
Is it my processor and low MHZ????
A J A
Posted: Mon Oct 25, 2004 12:09 pm
by carbon_unit
It will run fine on a 600e. Make sure you have as much memory in it as you can, linux likes memory.
You will need a floppy drive to do this.
Read the third post in the link below.
http://forums.xandros.com/viewtopic.php?t=3807
It will take a while for it to boot but once it is booted it will run fine.
I have run it on a 600 with a 366 cpu and290Mb memory and on a 570 333 with 128Mb memory.