Take a look at our
ThinkPads.com HOME PAGE
For those who might want to contribute to the blog, start here: Editors Alley Topic
Then contact Bill with a Private Message

Solution for malfunctioning T420s latches

T400/410/420 and T500/510/520 series specific matters only
Post Reply
Posts: 15
Joined: Tue Feb 26, 2008 9:43 pm
Location: Bandung, Indonesia

Solution for malfunctioning T420s latches

#1 Post by wpyh » Sat Oct 31, 2015 10:32 am

I just got my T420s secondhand, and the latches are malfunctioning. When I try to close the lid, I need to exert great force to make the latches click.

The problem is with the latches themselves, they are slightly bent outwards (radially away from the hinges). Maybe it happened due to frequent opening/closing of the lid, or some sort of manufacturing defect. I wasn't able to take the latches out and replace them though. When the latches are bent outwards, they tend to go between the slider and the laptop casing.

The solution is:
1. Work on one latch, either the left one or the right one.
2. Use a soldering iron to heat the latch side facing the hinges (the inner side). The soldering iron should contact the latch. At the same time, apply some pressure and push the latch towards the hinges (inwards).
3. If done correctly, the latch will bend back and the lid will close nicely again. Check by swinging the lid so that it almost closes, and peek from the sides to see if it is indeed positioned correctly.
4. Do the procedure for the other latch.

Sorry for the messy explanation, I just thought there may be other users facing this same problem. I hope this post will be of help.

If you need further explanation, I will be happy to assist / explain more.
Thinkpad X32 - Thinkpad X60 - Thinkpad X61s - Thinkpad T420s

Post Reply
  • Similar Topics
    Last post

Return to “ThinkPad T400/410/420 and T500/510/520 Series”

Who is online

Users browsing this forum: GMGolds and 28 guests