In the meantime, I took its disk, put it into my completely-stable R61, reactivated, and shipped the R61 to that relative.
A couple months pass, and I receive word that the R61 is having troubles. I was told:
When I turn it on, it starts to do a normal start-up. The desktop screen comes on and about 3 seconds later, the computer shuts itself down. I then push the on button again and it starts up normally. I went through this routine 6 times today spread out over 12 hours.
Any ideas on this one? I never had any problems with the machine. I don't know if this is going to get worse - it's obviously only a nuisance now. I had the owner confirm that it reproduced with the battery removed, and similarly on battery with the power brick disconnected. The machine is running Windows 10 but that would seem to be irrelevant here.
Apparently W10 has something like a "fast-booting" option, which has been the downfall of many a laptop...
I am totally against W10, especially after reading so many negative postings all over the web.
Check out The Boardroom for Parts, Mods and Other Services.
Perhaps it automatically switched to assuming the computer has UEFI firmware - which is of course not present on an older machine like the R61.
Could I get some clarification on the other suggestion, with respect to UEFI setting in the BIOS? I'm not sure what to look for.
- Senior Member
- Posts: 938
- Joined: Fri Oct 11, 2013 7:45 pm
- Location: North Ridgeville, Ohio, United States
Wife's: T61p T9500·2010 FX570m·WUXGA | X220T i7-2640M
- Posts: 16293
- Joined: Sun Feb 25, 2007 11:28 am
- Location: Brodheadsville, Pennsylvania, USA
George (your grouchy retired FlexView farmer)
AARP club members:A31p,T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
- Senior Member
- Posts: 828
- Joined: Wed May 19, 2010 11:21 pm
- Location: Pardubice, Czech Republic
The disk is responsible -- or rather the OS on the disk. Install Linux on a drive and mail it to them.
Include some remote desktop software on the drive so you can get on the machine and hold their hand.
- Similar Topics
- Last post
Who is online
Users browsing this forum: No registered users and 6 guests