Take a look at our
ThinkPads.com HOME PAGE
For those who might want to contribute to the blog, start here: Editors Alley Topic
Then contact Bill with a Private Message

T440p not turning on after clunkpad replacement

T430 and later, plus T530 and later series specific matters only
Post Reply
Posts: 1
Joined: Sun Jun 14, 2020 5:21 am
Location: Zagreb, Croatia

T440p not turning on after clunkpad replacement

#1 Post by ist » Sun Jun 14, 2020 5:33 am


Finally decided to change my clunkpad. Disassembly went mostly fine. I had some trouble with the palmrest snaps on the power button side. When I reassembled everything I couldn't turn it on. No lights, no fans spinning. Disassembled it again and checked if something plugged off but there was nothing obvious to see. What could go wrong? Maybe I broke the power-button card?


Posts: 6
Joined: Wed Jun 03, 2020 6:48 pm
Location: Wellington, NZ

Re: T440p not turning on after clunkpad replacement

#2 Post by whatsuphelpline » Wed Jul 22, 2020 7:01 am

I'm no expert here but there is a blue cable and clamp just below the power button, is that still intact? That's the first thing I can think of. Not even sure whether that is power related though.

Post Reply
  • Similar Topics
    Last post

Return to “ThinkPad T430-T490 / T530-T590 Series”

Who is online

Users browsing this forum: No registered users and 37 guests