My impatience was stronger than my lazyness
Code: Select all
Dear T'padders.
A while ago I bought a "headless" X200s, the previous owner had broken the screen. I bought the parts over the net and did the AFFS mod. Works fine, so far so good.
A while after that I bought a complete WXGA+ assembly (LCD, cover, bezel, cable, antennae, etc. etc) ready for plug & play. Some days ago I bought another "headless" X200 (7455-8GG), it arrived today and when I installed the WXGA+ lid it did not work properly, screen shows everything with no almost no brightness.
I tried then the same lid on the X200s and it works :!: Means for me screen is not broken/defective
If I try the AFFS WXGA screen on the new X200 it works too :!: Means for me the X200 is not broken/defective
I updated the BIOS of the X200. No changes :(
What am I doing wrong? Did I overlook something? Am I using the wrong logic? I know I could swap the lids between the X200s/X200 but being me a lazy person I'd like to avoid double work. Plus I'm puzzled what's going on...
Thanks a lot in advance!




