I've been trying to accomplish this with RMClock.
However, the lowest voltage setting is 1.025V, which is higher than the 0.965V that the L7500 1.6GHz Core2Duo is rated at. Was anyone able to successfully undervolt their CPU?
Undervolting the X61 Tablet
-
axur-delmeria
- ThinkPadder

- Posts: 1271
- Joined: Mon May 28, 2012 5:49 am
- Location: Metro Manila, Philippines
Re: Undervolting the X61 Tablet
Look under advanced CPU settings or something.
There's a checkbox there that sets whether the CPU is a desktop or laptop processor.
Under win7 it's usually set to "Desktop".
Uncheck it and check "Laptop"
You would then gain access to the lower voltages. In my X61 with T8100, it goes down to 0.95v. I don't know how low it goes for lower-voltage L7xxx CPUs.
There's a checkbox there that sets whether the CPU is a desktop or laptop processor.
Under win7 it's usually set to "Desktop".
Uncheck it and check "Laptop"
You would then gain access to the lower voltages. In my X61 with T8100, it goes down to 0.95v. I don't know how low it goes for lower-voltage L7xxx CPUs.
Daily driver: X220 4291-P79 i5-2520M
In reserve: X61 T7500, X60 T2300
In pieces: X60s CS U1300 [board only], two retired but working X61Ts
RIP: 760XD 9546-U9E
In reserve: X61 T7500, X60 T2300
In pieces: X60s CS U1300 [board only], two retired but working X61Ts
RIP: 760XD 9546-U9E
-
- Similar Topics
- Replies
- Views
- Last post
-
- 4 Replies
- 1452 Views
-
Last post by kfzhu1229
Thu Feb 09, 2017 6:38 pm
-
-
Undervolting CPU in Windows 8 / 10 ? RMclock doesn't work any more.
by zoltan87 » Fri Feb 17, 2017 10:26 am » in ThinkPad T6x Series - 6 Replies
- 2489 Views
-
Last post by lab
Sat Mar 18, 2017 11:55 am
-
-
-
I thought I wanted to retire this X61 Tablet...
by axur-delmeria » Fri Mar 24, 2017 2:16 pm » in Thinkpad X6x Series incl. X6x Tablet - 2 Replies
- 988 Views
-
Last post by axur-delmeria
Sat Mar 25, 2017 10:19 am
-
-
-
WTB: A X61 Tablet Motherboard and 8GB of RAM
by LibreKiller » Fri Mar 31, 2017 12:33 am » in Marketplace - Forum Members only - 1 Replies
- 255 Views
-
Last post by wujstefan
Fri Mar 31, 2017 2:28 am
-
Who is online
Users browsing this forum: No registered users and 6 guests



