Swapped screen, now digitizer doesn't display position

[Utwig]

OK, I managed the screen swap on my X61 tablet for a X60 screen. Now digitizer no longer detects position of the pen. Once I approach the pen towards screen, the cursor turns to digitizer but doesn't move unless I move the trackpoint.

During the screen swap I did a brief test so I know digitizer works. It also now doesn't work with old screen.

I'm suspecting a disconnected cable somewhere or damaged board that connects monitor cable to the motherboard - the FRU 41W1477, since I bent it a bit during reassembly

Do you have any suggestions?

Plan of action is to order 41W1477 since it costs only 10 EUR and see then.

[Utwig]

Swapped 41W1477 but still cursor point is just stuck in same position if i approach screen with pen.

Update: it was driver problem, I tried with RedHat Linux drive and fresh install of Windows 7 and it works.