
Is it correct to assume GPU on my T61p was made in 2010? PIC
-
scl23enn4m3
- Posts: 34
- Joined: Sun Jun 06, 2010 11:48 am
- Location: Princeton, NJ
Is it correct to assume GPU on my T61p was made in 2010? PIC
November 2010 to be exact. I've made mistakes reading these numbers before, but I've never done it on the actual GPU. Would the top right sequence be the correct one to look at? It's the only one that makes sense.


-
ajkula66
- SuperUserGeorge

- Posts: 15740
- Joined: Sun Feb 25, 2007 11:28 am
- Location: Brodheadsville, Pennsylvania
Re: Is it correct to assume my GPU on my T61p was made in 2010?
I shouldn't post when mu brain is fried.
Apologies for the confusion.
Apologies for the confusion.
Last edited by ajkula66 on Wed Jul 17, 2013 12:03 am, edited 1 time in total.
...Knowledge is a deadly friend when no one sets the rules...(King Crimson)
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
-
scl23enn4m3
- Posts: 34
- Joined: Sun Jun 06, 2010 11:48 am
- Location: Princeton, NJ
Re: Is it correct to assume my GPU on my T61p was made in 2010?
Dang. I'm glad I asked. Thanks for the response. Based on your reaction, I take this isn't common?ajkula66 wrote:No.
Your chip is missing the actual date code, which should be in the middle of it...
Edit: I'm comparing it to other chips that I found on Google Images, and none of them seem to have any more numbers than mine. Do you happen to have an example of where the date should be located?
Last edited by scl23enn4m3 on Tue Jul 16, 2013 11:27 pm, edited 2 times in total.
-
ajkula66
- SuperUserGeorge

- Posts: 15740
- Joined: Sun Feb 25, 2007 11:28 am
- Location: Brodheadsville, Pennsylvania
Re: Is it correct to assume my GPU on my T61p was made in 2010?
deleted.
Last edited by ajkula66 on Wed Jul 17, 2013 12:04 am, edited 1 time in total.
...Knowledge is a deadly friend when no one sets the rules...(King Crimson)
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
-
scl23enn4m3
- Posts: 34
- Joined: Sun Jun 06, 2010 11:48 am
- Location: Princeton, NJ
Re: Is it correct to assume my GPU on my T61p was made in 2010?
Gotchya. Thanks for your input!ajkula66 wrote:TuuS would be the one to ask, but I've never seen something quite like what your picture shows, and I've gone through my fair share of T61/p machines and then some...scl23enn4m3 wrote:Dang. I'm glad I asked. Thanks for the response. Based on your reaction, I take this isn't common?
-
ajkula66
- SuperUserGeorge

- Posts: 15740
- Joined: Sun Feb 25, 2007 11:28 am
- Location: Brodheadsville, Pennsylvania
Re: Is it correct to assume my GPU on my T61p was made in 2010?
Looking around the web I've bumped into a few images of chips that resemble yours.
Might have something to do by where they were manufactured specifically, since there was more than one plant involved.
Let's wait for Mr. TuuS since I'm getting confused here, and being as tired as I am I'm starting to question everything which is not good...
Might have something to do by where they were manufactured specifically, since there was more than one plant involved.
Let's wait for Mr. TuuS since I'm getting confused here, and being as tired as I am I'm starting to question everything which is not good...
...Knowledge is a deadly friend when no one sets the rules...(King Crimson)
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
-
ajkula66
- SuperUserGeorge

- Posts: 15740
- Joined: Sun Feb 25, 2007 11:28 am
- Location: Brodheadsville, Pennsylvania
Re: Is it correct to assume my GPU on my T61p was made in 2010?
ajkula66 wrote:I shouldn't post when mu brain is fried.
Apologies for the confusion.
...Knowledge is a deadly friend when no one sets the rules...(King Crimson)
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
Re: Is it correct to assume GPU on my T61p was made in 2010? PIC
Your reading of the date is correct, but this isn't conclusive that your gpu was actually produced on that date since we have seen a flood of Fake chips from China that have been used on 3rd party refurbished boards. It's believed these are old chips that have had the dates polished off and new ones etched on. This has been a common practice for decades and hasn't been a major problem until they started using defective chips or rebranding chips to imply they were military grade. However if your board was supplied by ibm/lenovo and carries this date, then you can be pretty sure it's a new GPU. I'd suggest pulling the bottom cover and looking for an orange "serviceable used part" sticker which would mean that the board is most likely a genuine lenovo refurb and has had the chip replaced.
These chips haven't been mass produced since 2008 and manufacturing them in small quantities is very expensive so nVidia only makes them as needed and only for OEM partners, this has created a demand for chips and perhaps the reason why the chinese knock-offs have flooded the market.
These chips haven't been mass produced since 2008 and manufacturing them in small quantities is very expensive so nVidia only makes them as needed and only for OEM partners, this has created a demand for chips and perhaps the reason why the chinese knock-offs have flooded the market.
-
scl23enn4m3
- Posts: 34
- Joined: Sun Jun 06, 2010 11:48 am
- Location: Princeton, NJ
Re: Is it correct to assume GPU on my T61p was made in 2010? PIC
Thanks for chiming in on this thread TuuS. That's really messed up regarding the fake chips. I didn't even think scams like that were possible in this day and age. Then again I guess I shouldn't be too surprised as everything else seems to have been already faked.
Thankfully I'm the original owner and everything was replaced under warranty straight from Lenovo, so I'd say chances are slim it's a fake. I'll take the board completely out today and look for that sticker. Any chance the FRU would be located on that sticker? Thanks again!
Thankfully I'm the original owner and everything was replaced under warranty straight from Lenovo, so I'd say chances are slim it's a fake. I'll take the board completely out today and look for that sticker. Any chance the FRU would be located on that sticker? Thanks again!
Re: Is it correct to assume GPU on my T61p was made in 2010? PIC
If the board was installed by lenovo, then it's a good chip. As far as I know they don't source boards on taobao or ebay, so you have nothing to worry about.
The FRU on replacement boards is usually under the ram modules and is most likely 44c3931 for a 15.4" T61p, or perhaps a 43y9048.
The FRU on replacement boards is usually under the ram modules and is most likely 44c3931 for a 15.4" T61p, or perhaps a 43y9048.
-
scl23enn4m3
- Posts: 34
- Joined: Sun Jun 06, 2010 11:48 am
- Location: Princeton, NJ
Re: Is it correct to assume GPU on my T61p was made in 2010? PIC
Spot on TuuS!TuuS wrote:If the board was installed by lenovo, then it's a good chip. As far as I know they don't source boards on taobao or ebay, so you have nothing to worry about.
The FRU on replacement boards is usually under the ram modules and is most likely 44c3931 for a 15.4" T61p, or perhaps a 43y9048.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
Power cord and adapter for T43 made for the UK
by Sudevan » Wed Jan 25, 2017 4:44 pm » in ThinkPad T4x Series - 6 Replies
- 1529 Views
-
Last post by Sudevan
Thu Jan 26, 2017 5:15 pm
-
-
-
FS: US-layout NMB (Made in Thailand!) keyboard for 15" T4x/p's & R5x/p's (P/N 93P4750, FRU 93P4780)
by Johan » Sun Feb 19, 2017 5:52 am » in Marketplace - Forum Members only - 1 Replies
- 249 Views
-
Last post by Johan
Sun Feb 19, 2017 5:53 am
-
-
-
FS: 2010 MBP 15" WSXGA+ Matte $250
by slangeditorial » Sun Jun 18, 2017 1:59 pm » in Marketplace - Forum Members only - 0 Replies
- 129 Views
-
Last post by slangeditorial
Sun Jun 25, 2017 4:16 pm
-
-
- 7 Replies
- 1865 Views
-
Last post by RealBlackStuff
Wed Jan 04, 2017 11:29 am
Who is online
Users browsing this forum: No registered users and 6 guests




