Access IBM missing in action

[jwhpa]

I received the T40 I bought on eBay today, but I'm unable to access "Access IBM". Unfortunately, I received no documentation with the machine. I logged into the IBM support site and upgraded the drivers today. One of the upgrades was "Access IBM," but I can't get it to run. I'm assuming to normally do so you only need to push the designated button.
Thanks for any suggestions,
JH

[G-Man]

If you have installed Access IBM, it should appear in Start>All programs>Access IBM>Access IBM

As far as I know to make the Access IBM key work, you need to install Hotkey driver.

Regards,
G-Man

[mdarnton]

Did you load the software after you decompressed the file you downloaded? Start the downloaded file again, and notice where it's decompressed everthing (on my computer it's C:\DRIVERS\W2K\ACCONWLD), go there, and click on the setup file, which installs the software and drivers. If you didn't do this, you haven't finished the installation yet.